WECOUNT AI-Powered Portable Home Gym User Manual
- June 6, 2024
- WECOUNT
Table of Contents
Devices
Platform
Press switch, the blue light turns on.
Blue light flashing pair to your phone.
Becoming green light, Bluetooth connect succeeded.
Clip resistance bands on the platform.
Change resistance as you need through adjusting Mesh belt length. push button on the buckle to draw out or take back mesh belt.
3pcs of workout bar connection.
2pcs of workout bar connection.
If you need more resistance from the same bands, changing the way to connect is always a good option.
If you need more resistance from the same bands, changing the way to connect is always a good option.
Bands can clip on both rings of the platform.
Each side of the smart sensor can hold up to 50kgs/100lbs of resistance from bands, approximately 4pcs of 30lbs green bands, or 3pcs of 40lbs black bands.
Each side of the smart sensor can hold up to 50kgs/100lbs of resistance from bands, approximately 4pcs of 30lbs green bands, or 3pcs of 40lbs black bands.
FCC Statement
This equipment has been tested and found to comply with the limits for a Class
B digital device, pursuant to part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates, uses, and can radiate
radio frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and
on, the user is encouraged to try to correct the interference by one or more
of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
Caution: Any changes or modifications to this device not explicitly approved by the manufacturer could void your authority to operate this equipment.
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and
(2) this device must accept any interference received, including interference that may cause undesired operation.
RF Exposure Information
The device has been evaluated to meet general RF exposure requirements. The device can be used in portable exposure conditions without restriction.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>