Polaroid PSS0417 Bluetooth Selfie Stick with 6 Inch Ring Light and Tripod User Manual

PSSO417
Selfie Stick Tripod & Ring Light
User Manual

Before You Begin…

READ CAREFULLY AND SAVE THIS MANUAL

Caution

• This isNOT AMY, please keep away from children
• Do NOT leave charging overnight
• Do NOT submerge in water
• Do NOT be exposed to water, fire, high temperatures, or humidity
• Do rot open this product,ct or attempt to repair the unit yourself should not be working
• Do NOT store in an enclosed vehicle or area
• Do rot disassemble or attempt to repair
• Do rot short circuit the battery with any metal objects
• This device contains a battery, and should NOT be disposed of with regular household waste. Please consult the local authorities on the correct way to dispose of this device

Technical Specs

• Dimensions: 6.3 x 2.8 x 76 – 42 in
• Rechargeable Ring Light Battery: 1200 mAh
• Charging Cable: Micro-USB
• Charging Cable Length: 39 in
• Remote Battery: CR1632
• Weight: (17 lb

In the Box

• PSSO417 – Seine StickTripod & Ring Light (xl)
• Micro-USB Charging Cable (x1)
• Instruction Manual (x1)

**Getting Started

**

Installing and Removing the Control Panel Box

Powering ON/OFF

• Press + hold the camera button for 3 seconds to power ON or OFF.
• When powered ON, the LED indicator will flash for 4 seconds, and the selfie light will enter Bluetooth pairing mode. It may automatically reconnect to a previously paired device.

Note: the selfie light will automatically power OFF after 5 minutes without a Bluetooth connection.

Bluetooth Pairing

1. Power the selfie light ON. The selfie light will enter Bluetooth pairing mode, and the LED indicator will flash BLUE.
2. Turn your device’s Bluetooth on, and search for new Bluetooth Select PSSO417 when it appears on the list of found devices.
3. After a successful pairing, the LED indicator on the selfie light will turn OFF.

**Taking a Photo

**

Power the control panel ON and connect to your device.

• Press the camera button to take a photo. The LED indicator on the control panel will flash BLUE once.

Note: The selfie-light will enter standby mode after no photos are snapped for 10 minutes, and will automatically power OFF after 10 minutes in standby mode.

Replacing the Control Panel Battery

1. Remove the control panel box from the selfie light.
2. Using the groove on the corner of the control panel box, open the
3. Remove the old battery, and dispose of it according to local Do not dispose of it with regular household waste.
4. Install a new CR1632 battery. Replace the control panel box cover, and install the control panel box back into the selfie light.

Note: Low battery power can cause selfie photography dysfunction. If you notice issues with the selfie stick, try replacing the battery.

Charging the Ring Light

**** Plug the micro-USB (smaller) connector of the included micro-USB charging cable into the micro-USB port on the ring light.
Plug the USB (larger) connector into a USB power source, such as the USB port on a computer or an EV USB wall adapter (not included).
Charge for 3 hours before using.

Using the Ring Light

Charge the ring light before using it.

• Press + hold the [Power] button on the ring light to power ON or OFF.
• Quick press the [Power] button to flip through the different light brightness settings.
• When powered OFF, the ring light will remember the last brightness setting it was on.

Unfolding the Tripod

To unfold and adjust the tripod, pull the legs outward where they connect to the selfie stick.

Compliance Information

FCC Information
This device complies with Part 15 of the FCC Rules.
Caution: Any changes or modifications not expressly approved could void the user’s authority to operate the equipment.

Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation.This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on. the user is encouraged to try to correct the interference by one or more of the following measures:

• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/1V technician for help.

This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: Millis device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.
This product complies with the requirements for Part 18 of the FCC Rules. Although this product complies with FCC, it may interfere with other devices. If this product is found to interfere with another device, separate the other device and this product.

Radiation Exposure information
This device has been evaluated to meet general RF exposure requirements. The device can be used in portable exposure conditions without restriction.

WARNING U4on Battery Inside
This product is fitted with a Li-ion battery. Do not damage, open, or dismantle the battery, and do not use it in damp and/or corrosive conditions. Use only compatible chargers. Never dispose of batteries in a fire, and never expose them to high temperatures. Do not expose the product to temperatures exceeding 60°C (140°f).

Rating Label Definitions

Dredcurrant syrrtd.
Tits symbol *Mee that the product must rot be Clecerded as household waste, and should be delivered to on spcecceete collection facility for recycled. Proper impanel and recycled haps protect natural raindrops. human health and the onercernam
This symbol &lenges and declares that this equipment carnelian wall beady charging which COMPIleS with Calfornia CEC and energy efficiency.
This symbol rWeSengi FCC Declameon a’ COMCnerty and compliance

Warranty Information

3-Month Limited Warranty
For technical service on this product, please contact:

Servicio al Cliente
Fono: 02-23410466
Av. Italia 1729, alluring
info@sgservicios.cl
www.sgservicios.cl

Have questions? We’ve got answers.
Visit us at customersupport123.com

InSteepiCOgriatta: instantly measuring The Polaroid arise Border and Polaroid Color&Marlin logos let you SsoorNictNe purchased a product that earrcOles the

best oueUties of*: brand and that zonal. te to as rich herbage (Squattyand innovation.

2021. All rights reserved.
      Polaroid, Polaroid Color Spectrum, and Polaroid Classic Border Logo are trademarks of PLR IP Holdings, ILC, used under license. PLR IP Holdings LLC does not manufacture this product or provide any manufacturer’s warranty or support.

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>