AOHi AOCP002 Wireless Power Bank User Manual

USER MANUAL
WIRELESS POWER BANK

Please read this user manual carefully before using the product and keep it for future reference.

Getting Started

Notes

• For the fastest and safest charge, use an AOHI cable, your device’s original cable, or another certified cable (such as MFi).

Lightly press the switch, the PD output turns on while the power indicator shows the current power, if the PD has no load output, the PD interface turns off after 30 seconds.

• Charging power indication: when the power is 1%-33%, the light is yellow and it is in the breathing flashing state. (the power is 34%-67%,blue; the power is 68%-100%, green)
• Discharge power indication: when the power is 1%-33%, the light is yellow and goes off after 10 seconds. (the power is 34%-67%, blue; the power is 68%-100%, green)

Specifications

To get USB Power Delivery, the following are required

• Device (phone, tablet, laptop) that supports USB Power Delivery
• USB-C charger with USB Power Delivery
• USB-C to USB-C cable or Apple MFi USB-C fo Lightning Cable

Attention

• Use aohi original or authorized cable only.
• Recharge the power bank once every six months when not in use.
• Keep away from liquids. Stop using if it is wet to avoid fire hazards, battery leakage, electric shock or explosion.
• Keep away from high temperatures.
• Never try to dismantle, repair or refit this unit by yourself.
• Do not try to disassemble, repair or refit the device by yourself.
• Do not knock this product. Avoid dropping.
• Do not clean this unit with soap or another detergent to avoid damage.
• Stop using immediately if deformation, breakage, overheating or abnormal odor occurs.
• Keep away from flammables, smoke, and heat surface.
• Keep out of reach of children.
• Dispose of this product as per local law and regulations.

Packaging

• Wriless Power bank
• User Manual
• Service Card

FCC Statement

This device complies with part 15 of the FCC rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment. NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

• Reorient or relocate the receiving antenna. ·Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help. The device has been evaluated to meet general RF exposure requirements.

The device can be used in portable exposure conditions without restriction.

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>