Guangzhou V Solution Telecommunication Technology V2804REW-RGW Optical Network Unit Installation Guide
- June 6, 2024
- Guangzhou V Solution Telecommunication Technology
Table of Contents
Optical Network Unit V2804REW-RGW
Quick Installation Guide
1. Indicator and Interface Description
1.1 Product Picture
1.2 Application Chart Figure 2 Application Chart
1.3 Panel Lights
Figure 3 Panel Lights
1.4 Interface/button Panel
Figure 4 Interface/button Panel
2. Packing List
3. Certification
4. Hardware Installation
Installation Environment Requirements
ONU equipment must be installed in the interior, and to ensure the following
conditions:
- Confirmation at the ONU installation at sufficient space to facilitate cooling machine.
- ONU suitable operating temperature of -5 ℃ ~ 55 ℃, humidity 10% to 90%.
- Device workplace should avoid radio transmitters, radar stations, and high-frequency interference from power equipment.
Equipment Installation
1. Installed on the desktop
Place the ONU on a clean bench, this installation is relatively simple, you
can observe the following operation:
- Ensure the smooth workbench.
- Around the device enough space for heat dissipation.
- Do not place objects on the device.
2. Mounted on the wall
- Observation ONU equipment chassis two cruciform recess, in accordance with the position of the groove, installed two screws in the wall.
- The original selected two mounting screws gently snap into recesses aligned.
- Slowly let go, so that the device under the support of the screw hanging on the wall.
3. Connect fiber, network cable and power adapter to the corresponding interfaces, and turn on the power of product.
FCC Warning
This device complies with part 15 of the FCC rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.
Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
Radiation Exposure Statement
This equipment complies with FCC radiation exposure limits set forth for an
uncontrolled environment. This equipment should be installed and operated with
minimum distance 20cm between the radiator and your body.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>