ResMed Prior Fitting Mask User Guide
- June 6, 2024
- ResMed
Table of Contents
Fitting Guide
Prior to fitting your mask, remove the orange spring frame support from the
rear of your mask and retain it for future use.
| | **
---|---|---
• With both lower headgear clips released, position the cushion at an angle on
the nasal bridge.| • Keeping the upper position of the mask in place, swing
the lower half of the mask down against the face.| • Hold the mask firmly
against the face and pull the headgear over the head.
| |
• Bringing the lower straps below the ears, clip the headgear into the lower
part of the spring frame.| • Unfasten the Velcro®, pull the upper headgear
straps evenly until they are comfortable and firm, and reattach the Velcro.| •
Repeat step 5 with the lower headgear straps.
• Connect one end of the air tubing to the swivel and the other end to the
airflow device.
• Turn on the airflow device.
Tip One| Tip Two**
---|---
|
• Ensure the headgear is correctly positioned on the head.| • Ensure the mask
sits mid-bridge and does not encroach on the eyes.
Quattro FX TM FULL FACE MASK
www.quattrofx.com
Manufacturer: ResMed Pty Ltd 1 Elizabeth Macarthur Drive Bella Vista NSW
2153 Australia.
Distributed by: ResMed Corp 9001 Spectrum Center Boulevard San Diego CA
92123 USA; ResMed (UK) Ltd 96 Milton Park Abingdon Oxfordshire OX14 4RY UK See
www.resmed.com for other ResMed locations worldwide.
Quattro is a trademark of ResMed Pty Ltd and Velcro is a trademark of Velcro
Industries B.V. © 2010 ResMed. Specifications may change without notice.
1013934/2 2010-08
0120
Global leaders in sleep and respiratory medicine
www.resmed.com
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>