Marsk T E9 Bluetooth Earphone User Guide

June 6, 2024
Marsk T

FCC Information
This device complies with Part 15 of the FCC Rules.

Caution: Any changes or modifications not expressly approved could void the user’s authority to operate the equipment.

Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

  • Reorient or relocate the receiving antenna.
  • Increase the separation between the equipment and receiver.
  • Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
  • Consult the dealer or an experienced radio/TV technician for help.

This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:

  1. This device may not cause harmful interference, and
  2. this device must accept any interference received, including interference that may cause undesired operation.

Radiation Exposure Information
This device has been evaluated to meet general RF exposure requirements. The device can be used in portable exposure conditions without restriction.

LITHIUM POLYMER BATTERY WARNINGS

This device contains a non-removable Lithium-Polymer battery. The battery must be recycled or disposed of properly. Contact your local waste management office for information on battery recycling or disposal.
Before You Begin…

READTHIS MANUAL CAREFULLY AND SAVE FOR FUTURE REFERENCE

To ensure safe and proper use, read all safety information before using the device. Only use with manufacturer-approved batteries, chargers, accessories, and supplies.

  • THIS DEVICE IS NOT ATOY , do NOT allow children or pets to use or play with this device.
  • Do not disassemble, modify, or repair the device.
  • Do not expose the device to extreme temperatures (heat or cold), open flames, humid, or wet conditions.
  • Do not submerge in water.
  • Low power may cause poor Bluetooth connection or sound distortion.
  • Do not overcharge battery.
  • If using with a USB adapter, make sure the adapter is not damaged.
  • Do not allow the USB port or the connectors of the supplied USB cable to be exposed to dust, or water, or come into contact with any conductive materials such as liquids, metallic powders, etc.
  • This device contains a built-in battery and should not be disposed of with regular household waste. Please consult the local authorities on the correct way to dispose of this device.
  • Always be aware of your surroundings when using the headset
  • Never use headset while driving a vehicle, riding a bicycle, or operating anything that requires your undivided attention

In the Box

  • BSBTH11 -Wireless Headset (xl)
  • Micro-USB Charging Cable (xl)
  • Instruction Manual (x1)

Location of Controls

  1. [ ] Volume switch
  2. [ ] Power switch
  3. [ ] Micro USB port
  4. [ ] Calling button
  5. [ ] Play / pause

**Pairing Your Earphone

**

Go to your device setting and activate the bluetooth feature, then search for devices, Find the earphones which appears as “BSBTH11′ on the device list and pair, the voice prompt will alert you if the pairing is successful

Charging the Headset

Plug the Micro USE (small) connector of the included USE charging cable into the Micro USE pat of the headset. Plug the USE Type-A (large) connector into a USB power source such as the USB port on a computer, or into a 5V/I LA USB adapter (nor included) and plug into a wall socket.

The headset LED indicate will slowly flesh RED while charging and turn sold RED when fully charged. On low batten?, the headset will automaticallycower Orr. Please recharge when this happens.

Powering ON/OFF

  • Slide up the [ ] switch to power ON, slide it down to power OFF.
  • Vlrhen powered on. a voice will be heard and the headset will enter Bluetooth pairing mode. They may automatically repair to any nearby. previously-Paired device with Ellueteddl enabled.
  • The heteeet will autemearrallY power OFF if it is rot paired toe Blutootn (levee after 5 [mutes.

Playing Music

To listen to music on the headset, you must be paired to a Bluetooth-enabled device. Consult the Bluetooth Pairing below for further instruction.

Adjusting Volume & Playback

  • Press the [ ] button to play and pause music.
  • To change the volume, long slide the [ ] switch to the top to volume up, and long slide it to the bottom to volume down.
  • To change the track, short slide [ ] switch to the top for next song, and short slide it to the bottom for previous song.

Bluetooth Pairing

  1. Power the headset on, the LED indicator will flash blue quickly, then flash both red and BLUE quickly into the pairing mode.
  2. Go into your device’s Bluetooth Settings, and search for new devices. When it appears, select BSBTH11 from the list of found devices.
  3. After a successful pairing, the LED indicator will turn off.

Phone Calls

To use the phone functions on the headset, you must be connected to a Bluetooth-enabled device.

  • Press the [ ] button to answer/hang up an incoming phone call. Playback will automatically pause.
  • Press + hold the [ ] button for 3 seconds to reject an incoming call.

90-day Limited Warranty

Territory: United States/Canada

LIMITED WARRANTY TO ORIGINAL CONSUMER

This product (including any accessories included in the original packaging} as supplied and distributed new by an authorized retailer is warranted by Southern Telecom, Inc. to the original consumer purchaser against defects in materials and workmanship (“Warranty”) as follows:

To obtain warranty service:

  • Visit our customer support portal: www.customersupport123.com
  • Select the brand and model of your device
  • Select Service Request and fill out the form to begin your inquiry
  • Exchanges require dated proof of purchase from an authorized retailer

Your product will be repaired or replaced, at our option, for the same or similar model of equal value if examination by the service center determines this product is defective. Products received damaged as a result of shipping will require you to file a claim with the carrier.

Warranty service not provided
This warranty does not cover damage resulting from accident, misuse, abuse, improper installation or operation, lack of reasonable care, unauthorized modification including software modifications such as the installation of custom firmware. This warranty is voided in the event any unauthorized person opens, alters or repairs this product. All products being returned to the authorized service center for repair must be suitably packaged.

NO WARRANTIES, WHETHER EXPRESS OR IMPLIED, INCLUDING, BUT NOT LIMITED TO, ANY IMPLIED WARRANTIES OF MERCHANTABILITY OR FITNESS FOR A PARTICULAR PURPOSE, OTHER THAN THOSE EXPRESSLY DESCRIBED ABOVE SHALL APPLY. DISTRIBU- TOR FURTHER DISCLAIMS ALL WARRANTIES AFTER THE EXPRESS WARRANTY PERIOD STATED ABOVE. NO OTHER EXPRESS WARRANTY OR GUARANTY GIVEN BY ANY PERSON,

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>

Related Manuals