RESMED Quattro Air Full Face Mask User Guide
- June 6, 2024
- ResMed
Table of Contents
Fitting Guide
| 
---|---
• Remove the elbow from the mask by pressing the side buttons and pulling the
elbow away.
• Pull headgear over your head with both lower headgear straps released.| •
Adjust both the straps of the upper headgear evenly until the mask is stable.
|
• Bring the lower straps below your ears and loop the headgear into the lower
hooks on the frame.| • Adjust the lower headgear straps evenly until the mask
is stable.
• The fitting should be firm but not uncomfortable.
• Do not over-tighten.
| 
• Connect the air tubing from your device to the elbow.
• Attach the elbow to the mask by pressing the side buttons and pushing the
elbow into the mask.
• Turn on your device so it blows air.| • Undo the fastening tabs on the upper
headgear straps.
• Reposition both of the straps evenly, only enough until a seal is achieved,
then reattach the fastening tabs.
• Your mask is now ready to use.
Note: For additional information, refer to the Quattro Air Full Face Mask User Guide.
Quattro™ Air
FULL FACE MASK
ResMed Pty Ltd
1 Elizabeth Macarthur Drive
Bella Vista NSW 2153 Australia
Distributed by: ResMed Corp 9001 Spectrum Center Boulevard San Diego CA
92123 USA. 
ResMed (UK) Ltd 96 Milton Park Abingdon Oxfordshire OX14 4RY UK. See
www.resmed.com for other ResMed locations worldwide.
Swift is a trademark of ResMed Pty Ltd and is registered in U.S. Patent and
Trademark Office. © 2011 ResMed. Specifications may change without notice.
1015126/1 2011-12
0123
Global leaders in sleep and respiratory medicine www.resmed.com
References
- Sleep apnea and COPD - learn about symptoms and treatment | ResMed
- Legal disclaimers and intellectual property - ResMed
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>