JOWAY JP268 Magnetic Wireless Power Bank User Guide
- June 6, 2024
- JOWAY
Table of Contents
JOWAY JP268 Magnetic Wireless Power Bank
Product Component Introduction
- Power button
- Indicator light
- USB output
- Lightning port
- Type-C input/output port
- Wireless Output
Charge for Power Bank
Put the enclosed USB of Type-C charging cable in power supply equipment.like AC adapter (1) or computer USB (2),plug into PD of Power Bank.
Wireless charging Instructions
- Click the button to turn on the wireless charging, and the wireless charging indicator (red) lights up, and the status light goes out after about 3 seconds if there is no load;
- After wireless charging is turned on, it outputs SW mode. If there is no load on the other output ports except for wireless charging, it will switch to lOW fast charging output mode in about 35 seconds.
Battery Indicator Instructions
Charging display(When charging the power bank )
The indicator light of 25%-100% is the power display light, and the single
blue flashing light is the charging display The 25% indicator flashes when the
power is 0-24%.
When the power level is 25%-49%, the indicator light is 25% on and 50%
indicator light is flashing.
When the power level is 50%-74%, 25% of the indicator light is longer than 50%
and 75% of the indicator light flashes. When the power is 75%-99%, 25% to 75%
indicator light is long and 100% indicator light flashes.
When the rear light is always on, the mobile power supply will have a small
current lo supplement.
Discharge display (Charging mobile/tablet by power bank):
Four indicator lights are on when the power is between 100% and 75%.
Discharge (Charging moblle / tablet by power bank) Instructions:
Discharge: Plug and play. When the mobile power supply in standby mode, the
power bank will charge the mobile when the mobile phone connected 1o the power
bank.The power bank will enter into the normal discharge working state, until
the electric equipment such as mobile phones or tablets is fully charged or
pull out the charging cable after 55 to 65seconds, the power bank will stop
discharge automatically. When the power bank didn’t continue to discharge in
55-65 seconds{i.e., no electricity) , power display will automatically put
out, shut down output, and enter into power saving mode. During the process of
working, if electricity equipment exist pulse power (i.e. charging for a
while, and then pause for a while), the interval period shall not exceed 55-65
seconds, otherwise the mobile power will turn off the output and enter the
powersaving mode. The power bank will display the power in real time without
pressing the button when the power bank is charging the mobile phone, tablet
computer or other electric devices.
Safe working parameter of power bank
No response with the being charged device
- Too low power with this product, please recharge for this product.
- The voltage of being charged device is not compatible with this product. Please check the voltage of your device.
- This product is wrong connected with being charged device.
- Charging cable and connectors are damaged. Please change them.
- This product is breakdown with internal circuit. Please contact after-sale service of the local agent.
- Using charging line to connect the output port to input port by mistake will cause short-circuit protection.
You should disconnect it. The product is connected to the AC charger or computer USB to be charged, to solve short circuit protection.
Warning
- Please charge the product every three months when it’s been idle status.
- Pull out the charging head as the charging indicator lights on. Avoid to damage the battery because of long time charging.
- Please use it under environmental temperature 0~45-C and relative humidity 20~70%Rh, keep far away from moist, hot and fire.
- Please keep product store in dry area, far away from moist and erosive materials.
- Don’t use rough chemical, like soap or cleanser to scrub it.
- It’s prohibited to disassemble, knock, or expose the product into fire or water.
- If the battery is expanded, weeping or has pecuiar smell, please stop to use it.
Guarantee and After-sale service
-
Guarantee:We guarantee 1 year since you buy this product.
-
Maintain:Your product possess of perfect quality. To extend the product life, please do as follows:
Be dry and keep away from damp and erosive goods. Don’t disassemble the product.Don’t store it under over-hot or over-cold environment. Don’t knock or crash the product. -
Warrant Clause:Please read carefully the user guide.We will not be responsible for any wrong operating or damage by human. Please provide the original invoice,or we have rights to reject to offer warrant service.
If your device had been dissembled or repaired by others people, we’ll not warrant for it. All of the products have been tested and verified. If it occurs over-hot, out of shape, breakage or other abnormal cases, please stop to use and contact with sales agent or our company.
FCC Warning
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.
Any changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.
Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
The distance between user and Wireless charging mat should be no less than 20cm
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>