Targus 000128 Wireless Mouse User Guide

June 6, 2024
Targus

Targus 000128 Wireless Mouse

Targus 000128 Wireless Mouse

Introduction
Thank you for your purchase of the Targus Midsize Multi-Device Wireless Mouse. The USB receiver conveniently stores inside the mouse for ease of use while traveling or on the go. This is a plug and
play device so no additional software is required.

Contents

  • Targus Wireless Mouse
  • 1 x AA Energizer Battery
  • USB Receiver
  • User Guide

System Requirements

Hardware
USB A port

Operating System
Windows® 10
macOS®
iOS®
Android

Product Name| Operation Frequency (MHz)| Maximum EIRP Power (dBm) (EU)| Working distance
---|---|---|---
Wireless Mouse: AMB582| 2402-2480MHz| 0.65| 10M
Wireless Mouse Receiver: AMB581R| 2403-2480MHz

FP

| 0.65

O

| 10M

Installing the Battery

  1. Insert the AA-size battery, making sure that the positive (+) and negative (-) ends of only one battery match the polarity indicators inside the battery compartment.Installing the Battery 1

  2. Close the battery cover, carefully fit the cover until it clicks into place.
    Use the “ON/OFF” switch to power the mouse on or off. Turn OFF to save battery power.

  3. When the battery is low , the lower power indicator light on the top will flash to indicate the battery need to be replaced.

Installing the Battery 2

NOTE: THE BATTERY WILL NEED TO BE IN THE SECURE, LOCKED POSITION BEFORE THE BATTERY COVER CAN BE PUT BACK IN PLACE.

Establishing the Connection of 2.4G Wireless

  1. Remove the USB receiver from the mouse.Establishing the Connection of 2.4G Wireless 1
  2. Plug the USB A receiver into an available USB A port on your computer.Establishing the Connection of 2.4G Wireless 2
  3. Click the wireless channel selection button to select first 2.4G channel, then the white LED indictor will light up and pair automatically.

Establishing the Connection of 2.4G Wireless 3

Power Saving mode:
After an extended period of time, if the mouse is not used after 30 minutes, it will automatically enter power saving mode to conserve power and increase battery life. Click on any mouse button resume the normal operation. The mouse may take a few seconds to reconnect with your computer.

Targus Wireless Mouse

Establishing the Connection of Bluetooth

Establish Pairing

  1. Turn on the mouse by sliding the power button to the ON position.
  2. Switch ON the Bluetooth function of your device and turn on the Bluetooth search mode.
  3. Press the connect button on the bottom of the mouse to select one of the 2 Bluetooth channel first , then hold down the button for 3 seconds to enable Bluetooth pairing mode, the white indicator light will flash for up to 2 minutes when the mouse is in paring mode.
  4. Tap “Targus AMB582” in the Bluetooth search menu on your device.
  5. The pairing will start automatically. Press the Bluetooth channel button to switch between devices once multiple devices have been connected.
  6. The Targus AMB582 is now connected to your device and the white light will stop flashing.

Establishing the Connection of Bluetooth

Technical Support

For technical questions, please visit:

US Internet: http://targus.com/us/support
Canada Internet: http://www.targus.com/ca/support
Australia Internet: http://www.targus.com/au/support
Email: infoaust@targus.com
Telephone: 1800-641-645
New Zealand Telephone: 0800-633-222
Latin America Email: latam.soporte@targus.com

Product Registration
Targus recommends that you register your Targus accessory shortly after purchasing it. Go to: http://targus.com/us/product_registration
You will need to provide your full name, email address, country of residence and product information.

Two Year Warranty

We pride ourselves on the quality of our products. For complete warranty details and a list of our worldwide offices, please visit www.targus.com. Targus product warranty does not cover any device or product that is not manufactured by Targus (including, but not limited to, laptops, smartphones, devices, or any other product that may be used in connection with the Targus product). Australian customers: For complete warranty details see warranty statement enclosed.

Targus is a registered trademark of Targus International LLC in the U.S. and in certain other countries.
Microsoft, Windows and Windows Vista are registered trademarks or trademarks of Microsoft Corporation in the United States and/or other countries. Mac is a trademark of Apple Inc., registered in the U.S. and other countries. Chromebook is a trademark of Google, Inc. All logos and registered trademarks are the property of their respective owners. ©2021 Targus, 1211 North Miller Street, Anaheim, CA 92806. All rights reserved.

Australian And New Zealand Consumers Only
Thank you for your purchase. Targus warrants to the original purchaser that its products are free from defects in materials and workmanship and, during the specified warranty period, and lasts as long as the original purchaser owns the product. The warranty period is stated on the packaging or in the documentation provided with this Targus product. Targus’ Limited Product Warranty excludes damage caused by accident, neglect, abuse, misuse, improper care, normal wear and tear, ownership transfer, or alteration. The limited warranty also excludes any product that is not manufactured by Targus (including, without limitation, laptops, smartphones, devices, tablets, or any other non-Targus item) that is used in connection with the Targus product.

In the event that the Targus product has a defect in materials or workmanship Targus will, after receiving a warranty claim and inspecting the product, at its discretion, do one of the following: repair, replace, or refund with the same or a similar product (or part) of no lesser quality and ship it to the original purchaser at Targus’ expense. As part of this inspection, proof of purchase will be required.

There is no charge for inspection. To make a warranty claim, please contact Targus Australia or New Zealand (see details below), or return the product to the place of purchase. The original purchaser must bear the cost of the delivery to Targus. Under Australian and/or New Zealand Consumer Laws, in addition to any warranty Targus gives, our products come with guarantees that cannot be excluded. You are entitled to a replacement or refund for a major failure and compensation for any other reasonably foreseeable loss or damage. You are entitled to have the products repaired or replaced if they fail to be of acceptable quality and the failure does not amount to a major failure. For any warranty question, contact Targus Australia Pty. Ltd. (i) by mail at Suite 2, Level 8, 5 Rider Boulevard, Rhodes NSW 2138, by phone AUS 1800 641 645 or NZ 0800 633 222 or by Email: infoaust@targus.com. For additional information, check out our website at targus.com/au/warranty.

Regulatory Compliance
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) This device must accept any interference received, including interference that may cause undesired operation.

Technical Support

For technical questions, please visit:

Internet
English http://www.targus.com/uk/support
French http://www.targus.com/fr/support
German http://www.targus.com/de/support
Spanish http://www.targus.com/es/support

Phone (language answered in):
Austria: 01 795 676 42 (German)
Belgium: 02-717-2451 (French)
Denmark: +45 35 25 87 51 (English)
Finland: +358 922948016 (English)
France: 01-6453-9151 (French)
Germany: 0211-6579-1151 (German)
Netherlands: 02 0504 0671 (English)
Norway: +4722577729 (English)
Portugal: +351 21 415 4123 (English)
South Africa: +27 211 003 270 (English) – Calls answered 10am-6pm South African time
Spain: 91 745 6221 (Spanish)
Sweden: 08-751-4058 (English)
Switzerland: +41 (0) 44 212 0007 (French or German)
UK: 020-7744-0330 (English)

Eastern Europe and others not listed above: +44 (0) 207 744 0330 (English)

Regulatory Compliance (applicable to products with electronic circuitry/parts only)
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may notcause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.

FCC Statement

Tested to Comply
This equipment has been tested and found to comply with the limits of a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy, and if not installed and used in accordance with the instructions may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

  • Reorient or relocate the receiving antenna;
  • Increase the separation between the equipment and receiver;
  • Connect the equipment into an outlet on a circuit different from that to which the receiver is connected;
  • Consult the dealer or an experienced radio/TV technician for help

Changes or modifications not authorized by the party responsible for compliance could void the user’s authority to operate this product.

Declaration of Conformity
Targus hereby declares that this device is in compliance with the essential requirements and other relevant provisions of Directive 2014/53/EU.

Targus Recycling Directive
At the end of this product’s useful life please dispose at an appropriate recycling collection point provided in your country.

Industry Canada statement
This device contains licence-exempt transmitter(s)/receiver(s) that comply with Innovation, Science and Economic Development Canada’s licence-exempt RSS(s). Operation is subject to the following two conditions:

  1. This device may not cause interference.
  2. This device must accept any interference, including interference that may cause undesired operation of the device.

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>

Related Manuals