verizon Wi-Fi Extender Mini Router User Guide
- June 6, 2024
- Verizon
Table of Contents
verizon Wi-Fi Extender Mini Router
For step-by-step instructions, visit setup.verizon.com/wifiextendermini or scan the QR code below.
For information about our privacy practices, visit verizon.com/about/privacy/
Make sure your router has an internet connection before setting up the Wi-Fi Extender Mini.
INSTALLATION
- Plug the Wi-Fi Extender Mini into a power outlet next to the router.
- When the light on front is solid yellow, press the pair button on the router and the Wi-Fi Extender Mini. Both devices will blink blue while pairing.
- Wait until you see a solid white light then unplug the Wi-Fi Extender Mini.
- Move and plug it into a power outlet in a weak Wi-Fi coverage area.
- Once the Wi-Fi Extender Mini boots up and the light turns solid white, your setup is complete.
REGULATORY COMPLIANCE NOTICES
Class B Equipment
This equipment has been tested and found to comply with the limits for a Class
B digital device, pursuant to Part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates, uses and can radiate radio
frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and
on, the user is encouraged to try to correct the interference by one or more
of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
FCC Caution: Any changes or modifications not expressly approved by the party
responsible for compliance could void the user’s authority to operate this
equipment.
This device complies with Part 15 of the FCC Rules. Operation is subject to
the following two conditions:
- This device may not cause harmful interference, and
- this device must accept any interference received, including interference that may cause undesired operation.
The operation of this device is prohibited on oil platforms, cars, trains,
boats, and aircraft, except that operation of this device is permitted in
large aircraft while flying above 10,000 feet.
Operation of transmitters in the 5.925-7.125 GHz band is prohibited for
control of or communications with unmanned aircraft systems.
RF Exposure:
This equipment complies with FCC radiation exposure limits set forth for an
uncontrolled environment. This equipment should be installed and operated with
minimum distance 21 cm between the radiator & your body.
This device is restricted for indoor use.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>