SANWA RC5 Type-A Receiver User Guide
- June 6, 2024
- SANWA
Table of Contents
Type-A Receiver
SANWA RC5
User Guide
How to pair USB radio dongle with the mouse
- Plug the USB radio dongle into the USB port of the target device.
- Press left+middle+right keys on the mouse. The LED will start blinking cyan (blue).
- Place the mouse close to the USB radio dongle (no farther than 10 cm).
- After successful pairing, the LED will go off.
How to use USB radio dongle with the mouse
- Plug the USB radio dongle into the USB port of the target device.
- Press any key on the mouse to activate the connection to the USB radio dongle.
Manufacturer: Shenzhen Hangshi Technology Co., Ltd
Add Hangshi Technology Park, Democracy West Industry Area,
Shajing Town, Baoan District, Shenzhen, China
©2021 Prestigio
NOTE: This equipment has been tested and found to comply with the limits
for a Class B digital device, pursuant to part 15 of the FCC Rules. These
limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates uses and
can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not
occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
– Reorient or relocate the receiving antenna.
– Increase the separation between the equipment and receiver.
-Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
-Consult the dealer or an experienced radio/TV technician for help
Changes or modifications not expressly approved by the party responsible for
compliance could void the user’s authority to operate the equipment.
This device complies with Part 15 of the FCC Rules. Operation is subject to
the following two conditions: (1) this device may not cause harmful
interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.
©2021 Prestigio