Ten Tronics A-1447 2.4GHz Wireless Audio System User Manual
- June 6, 2024
- Ten Tronics
Table of Contents
2.4GHz Wireless Audio
System User Manual
Transmitter
Bluetooth goes into discovery mode by default after power on.
ID: Music BT
Receiver
Pairing Transmitter and Receivers
Step 1
Press the Pairing button on the transmitter. The TX LED stars to flashes twice
per second. This indicates the device is waiting for a Receiver to connect.
Step 2
Within 10 seconds, press the pairing button on a Receiver. The Pairing LED on
the TX will become constantly lit. This indicates the receiver connection
succeeds. When connected with the TX, the Pairing LED on the RX will flash
once every 2.5 seconds. At this state, audio from the TX can be streamed to
the RX.
Step 3
Repeat steps 1 and 2. One Transmitter can be paired with up to 4 receivers.
Specifications
Wireless audio transmission quality: 44.1kHz CD quality with Texas
Instruments PPWTM point-to-point connection technology.
Wireless distance: 30 meters open site. Avoid to use in an overly complex
2.4GHz wireless environment.
Bluetooth: v4.2 with Qualcomm aptX, the distance over 10 meters.
A number of devices: one transmitter pair up to 4 receivers.
Receiver charging time: 1-hour charging run for 8 hours.
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installaon. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installaon. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
FCC Caution: Any changes or modifications not expressly approved by the party
responsible for compliance could void the user’s authority to operate this
equipment.
This device complies with Part 15 of the FCC Rules. Operaon is subject to the
following two conditions: (1) This device may not cause harmful interference,
and (2) this device must accept any interference received, including
interference that may cause undesired operaon. This device and its antenna(s)
must not be co-located or operating in conjunction with any other antenna or
transmitter.
FCC Radiation Exposure Statement:
This equipment complies with FCC radiation exposure limits set forth for an
uncontrolled environment.
This equipment should be installed and operated with a minimum distance 20cm
between the radiator & your body.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>