motorola MOTO BUDS Charge True Wireless In-Ear Headphones User Guide
- June 6, 2024
- Motorola
Table of Contents
motorola MOTO BUDS Charge True Wireless In-Ear Headphones User Guide
Quick Start Guide
1. Charging:
Fully charge before use
The device can be powered through a Type-C from any
CE compliant power source that implement the European interface as requested
by EN 301 489-52.
2. Pairing:
2.1 Ensure both buds are inside the charging case with lid closed then open up the lid. The buds will flash blue and red.
2.2 Select “Motobuds ANC” from the smartphone Bluetooth menu.
3. Fitting:
3.1 Insert the Vervebuds into your ear and rotate to fit comfortably.
3.2 To optimize the best fit and audio experience, it is recommended to try different earbud sizes.
4. Basic Operation
Additional Operation
Factory reset| Switch off both buds, then hold both MFB for 5 sec until the
indicator shows RED & BLUE, press MFB rapidly for 4 times
Reject a call| MFB 2sec
Voice command (Alexa)| MFB 2sec (R bud) (Android) MFB Single-tap (R bud) (iOS)
ANC ON_Transparent
_ANC OFF (when in idle)
| Double press MFB (L Bud) to toggle between ANC ON-
Transparent mode ->ANC OFF mode
ANC ON_Transparent
_ANC OFF (when listening music)
| Double press MFB (L Bud) to toggle between ANC ON-
Transparent mode ->ANC OFF mode
LED Indicator (earbud)
Pairing| Red-blue flash
Standby| Blue flash
Charging| Red steady
Fully charged| Off
Battery low| Red flash
ANC ON| White steady
FCC Statement
Changes or modifications not expressly approved by the party responsible for
compliance could void the user’s authority to operate the equipment.
This equipment has been tested and found to comply with the limits for a Class
B digital device, pursuant to Part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates uses and can radiate radio
frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and
on, the user is encouraged to try to correct the interference by one or more
of the following measures:
— Reorient or relocate the receiving antenna.
— Increase the separation between the equipment and receiver.
— Connect the equipment into an outlet on a circuit different from that to
which the receiver is connected.
— Consult the dealer or an experienced radio/TV technician for help
This device complies with part 15 of the FCC rules. Operation is subject to
the following two conditions (1)this device may not cause harmful
interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation
Read More About This Manual & Download PDF:
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>