Cabasse ELC0343 Pearl Remote Control Instruction Manual

June 6, 2024
Cabasse

REMOTE CONTROL ACTIVATION

Before first use, unscrew the screw (PH00 screwdriver), remove the cover, remove the protective tab, replace the cover and retighten the screw. The blue LED on the remote control flashes, waiting for pairing. PAIRING THE REMOTE CONTROL

  1. Connect the speaker to the mains.
  2. Switch on the speaker using the on / off button on the back.
  3. Press the “pairing” button on the back of THE PEARL/ THE PEARL AKOYA / THE PEARL SUB briefly. The LED “pairing” flashes.
  4. The LEDs on the remote control and THE PEARL stop flashing when the pairing is finalized.

Replacement of the CR-2450 type buttoncell: turn the remote control over, unscrewthe screw, remove the cover, remove the old battery, insert the new battery, marked “+” to the outside, replace the cover, tighten the screw.

FIRST USE

Connect THE PEARL THE PEARL AKOYA/THE PEARL SUB to the mains with the proper power cord.
THE PEARL / THE PEARL AKOYA / THE PEARL SUB are operationals as soon as the LED on the left of the rear panel opposite is lit in solid blue.
A voice announcement, if the volume of THE PEARL / THE PEARL AKOYA/ THE PEARL SUB is not at a minimum, indicates the status of the network connection: current, successful, failure.

STEREO USE WITH 2 THE PEARL / THE PEARL AKOYA / THE PEARL SUB
Use only one remote control to drive a stereo pair. Do not activate another remote in the same room.

COLOR CODES OF THE STATUS LED

  • CYAN: DLNA input: wifi, Ethernet, domestic streaming , internet streaming
  • GREEN:   Spotify Connect
  • WHITE: Aux In Input
  • YELLOW: Optical input
  • BLUE: Bluetooth input
  • RED: (flashing) Connexion to network failed
  • PURPLE: Automatic calibration running

Federal Communications Commission Notice
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.

Any Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.
Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

  • Reorient or relocate the receiving antenna.
  • Increase the separation between the equipment and receiver.
  • Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
  • Consult the dealer or an experienced radio/TV technician for help.

The device has been evaluated to meet general RF exposure requirement. The device can be used in portable exposure condition without restriction.

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>

Related Manuals