IDEC HG2G-5FT Remote Monitor and Control Instruction Manual
- June 6, 2024
- IDEC
Table of Contents
HG2G-5FT Remote Monitor and Control
Remote Monitor and Control
Configuration
(Applicable for 5.7″ HG2G-5FT, 8.4″ & 10.4″ HG3G, and 12.1″ HG4G Series OI
Touchscreens)
How to Configure the OI Touchscreens for Remote Monitor and Control
Instructions:
1. In WindOINV2 Software, select Configuration and click the Project
Settings.
2. In Project Settings, select Communication Interface tab. Under the
Interface Configuration, select Ethernet. Last, assign the IP Address for your
OI Touchscreen.
3. Next, select the Web Server tab in the Project Settings You will find 3
options under Remote Control and Monitoring. In this example, “Enable Remote
Control and Monitor” is selected.
Click the OK button to close the Project Settings. 4. Go to your IE browser
and enter the IP Address of the touchscreen. The IP Address used in the
example is : 192.168.100.113
5. If you are able to connect, then you will see this Windows Security ( as
shown below).
Note: · If you added a password in your touchscreen project, then you will
need to enter a User ID and a Password. · If you didn’t add a Password in your
project, then all you have to do is enter the User ID as “User” and leave the
Password blank. Press the OK button when finished.
6. Now you will see the System Information window (as shown below), select
“Control” (located on the left side) . This will allow you to remotely monitor
and control your touchscreen.
Below image is only an example of a project on what you will see next. As a
suggestion, you may want to select 256 Color Picture Format for quicker
response. Example:
The End
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>