zoOZ ZSE41 Door Window Sensor 700 Instructions
- June 6, 2024
- ZOOZ
Table of Contents
ZSE41 Door Window Sensor 700
SPECIFICATIONS
Model: ZSE41
Battery: CR2302 *1pc
Signal (Frequency): 908.42 MHz
Range: Up to 100 feet line of sight
Temperature Range: 32-104 ° F (0-40° C) For indoor use.
Approval: FCC/Z-Wave Plus Certified
FCC ID: 2AZ2VZSE41
- Zwave Door Sensor Window Sensor. Security or an intelligence sensor. Anytime and anywhere, giving you a full sense of security
- 700 series chip. You will get 50% faster wireless communication, enhanced encryption, 2 years of battery life.
- SmartStart QR for simplest possible device installation. Make your home really intelligent and safe.
- Mini Size Z-Wave Door Sensor.
- Home Automation: Work with Z-wave hub: SmartThings, Vera, Hubitat, Fibaro Home Centre, HomeSeer, Open Z-Wave, etc..
- With a waterproof case can work Outdoor.
FCC Caution.
This device complies with part 15 of the FCC Rules. Operation is subject to
the following two conditions: (1)
This device may not cause harmful interference, and (2) this device must
accept any interference received, including interference that may cause
undesired operation.
Any changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.
Note: This equipment has been tested and found to comply with the limits
for a Class B digital device, pursuant to part 15 of the FCC Rules. These
limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates uses and
can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not
occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
-Reorient or relocate the receiving antenna.
-Increase the separation between the equipment and receiver.
-Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
-Consult the dealer or an experienced radio/TV technician for help.
*RF warning for Portable device:
The device has been evaluated to meet general RF exposure requirements. The
device can be used in portable exposure conditions without restriction.
*RF warning for Mobile devices:
This equipment complies with FCC radiation exposure limits set forth for an
uncontrolled environment. This equipment should be installed and operated with
a minimum distance of 20cm between the radiator & your body.