Solinst 464 Mk3 Electronic Control Unit User Guide
- June 6, 2024
- Solinst
Table of Contents
**Solinst 464 Mk3 Electronic Control Unit User Guide
**
Control Panel
-
Select a menu item. Press and hold to turn Control Unit off.
-
Navigate through menus and menu items. -
Cycle through numbers and letters when editing.
-
Manual Control Valve: When pushed, solenoid opens, allowing drive cycle.
-
Regulator: Turn to increase or decrease pumping pressure.
-
Battery Enclosure: 4 AA alkaline batteries.
-
Air Out: Drive line to pump.
Note: Always use the supplied Drive Line with quick exhaust fitting. -
Air In: Supply line from compressed gas supply.
Notes:
- The Control Unit does not come with the batteries installed.
- Pressing any keypad button will turn the Control Unit on.
Main Menu
- A Timer indicates amount of time remaining before Unit turns off. Unit will automatically turn off after 5 minutes of being idle.
- B Battery life remaining. Icon will flash at 0% battery.
- C Percentage of battery life remaining.
- D Indicates a menu can be accessed using left cursor.
- E Indicates there is a sub-menu for the active menu item.
- F User Flow Rates: Create, Save, and edit customized drive/vent cycles.
- G LCD Contrast: Adjust contrast of LCD screen.
- H About: Displays installed firmware version.
Preset Flow Rates: Select a flow rate with predefined drive and vent cycles:
PRESET FLOW RATES
Flow| Drive| Vent
Low| 50 s| 25 s
Med| 10 s| 8 s
High| 3 s| 3 s
For further information contact: Solinst Canada Ltd. 35 Todd Road, Georgetown, Ontario Canada L7G 4R8
Web Site: www.solinst.com
E-mail: [email protected]
Tel: 905-873-2255 or
800-661-2023
Fax: 905-873-1992 or
800-516-9081
