ANDERIC FAN53T Ceiling Fan Remote Control Instructions
- June 6, 2024
- Anderic
Table of Contents
ANDERIC FAN53T Ceiling Fan Remote Control Instructions
INSTRUCTIONS
Note: This unit has 16 different code combinations. To set the code, perform these steps:
-
Setting the code on the remote:
-
Remove the battery cover. Press firmly below the arrow and slide battery cover off.
-
Slide the code switches to your choice of up or down position (factory setting is all up). Do not use this position. Use a small screwdriver or a ballpoint pen to slide firmly up or down (Fig. A ).
-
Replace the battery cover on the transmitter.
-
Setting the code on the receiver:
-
Slide the code switches to the same positions as set on your transmitter ( Fig. B ).
NOTE: The remote and receiver depicted in images may look different than your actual product.
If you do not know the code switch pattern, please see below chart for reference of all 16 codes.
Customer Support
For help, please contact Dan’s Electronics Etc., inc. customer support at 1-877-671-7173 or email [email protected]. Anderic® is a registered trademark of Dan’s Electronics Etc., Inc.