Tribit BTS20C XSound Go Bluetooth Speaker User Guide
- June 6, 2024
- Tribit
Table of Contents
Safety instructions
• Avoid dropping.
• Do not disassemble.
• Avoid extreme temperatures.
• Do not use the device outdoors during thunderstorms.
• Do not use any corrosive cleaner/oil to clean.
Specification
Bluetooth version: V5.0
Support: A2DP, AVRCP, HFP, HSP
Output power: 2 x 8W
Battery: 3.7V, 4400mAh
Battery charge time: 5 hour
Input: DC5V/1A
Dimension: 175 x 59 x 56 (mm)
Weight: 380g
|
---|---
|
---|---
Stereo Mode
- Make sure both speakers are on.
- Press on one of the speakers to enter the pairing state.
- Press on the other speaker for 5s, then release the button to enter Stereo pairing when you hear the “Stereo mode”. When you hear “Left channel” on the left speaker and “Right channel” on the right speaker, the “Stereo mode” is on.
Buttons
| Buttons | Operation & Function |
|---|---|
| Power on/off | Press to turn on/off |
| Bluetooth | Pre. to enter pairing mode |
| Volume + | Press to incr.se the volume level |
| Volume – | Press to decrease the volume level |
| play/pause | • Press to play/pause music and answer/end call |
• Long press to reject a call
• Press twice to skip to the next track
• Press triple to skip to the previous track
Status
| Indicator | Status |
|---|---|
| Blue indicator flashes slowly | Reconnection mode |
| Blue indicator flashes quickly | Bluetooth pairing mode |
| Blue indicator keeps on | The pairing has been successful |
| Red indicator flashes slowly | Low battery power (<15%), charge the speaker as |
required
Red indicator flash. quickly| Low battery power (<2%) and will automatically
power off after 5s charge the speaker immediately
---|---
Reset If this speaker has some problem, you can try to press and hold the
“Volume +” and “Volume —” buttons simultaneously for 5 seconds to reset, and
then pair again (delete the old pairing in your device).
FCC Statement
Changes or modifications not expressly approved by the party responsible for
compliance could void the user’s authority to operate the equipment. This
equipment has been tested and found to comply with the limits for a Class B
digital device, pursuant to Part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a
residential installation.
This equipment generates uses and can radiate radio frequency energy and, if
not installed and used in accordance with the instructions, may cause harmful
interference to radio communications. However, there is no guarantee that
interference will not occur in a particular installation.lf this equipment
does cause harmful interference to radio or television reception, which can be
determined by turning the equipment off and on, the user is encouraged to try
to correct the interference by one or more of the following measures:
— Reorient or relocate the receiving antenna.
— Increase the separation between the equipment and receiver.
— Connect the equipment into an outlet on a circuit different from that to
which the receiver is connected.
— Consult the dealer or an experienced radio/TV technician for help
This device complies with part 15 of the FCC rules. Operation is subject to
the following two conditions (1) this device may not cause harmful
interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.
RF warning for Mobile devices:
This equipment complies with FCC radiation exposure limits set forth for an
uncontrolled environment. This equipment should be installed and operated with
a minimum distance of 20cm between the radiator & your body.
Customer service
18-month limited warranty
• For FAQS and more information, please
• Email to: support@tribitaudio.com
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>