PHILIPS DCM-DyNet Communications Module Instruction Manual
- June 6, 2024
- Philips
Table of Contents
PHILIPS DCM-DyNet Communications Module
Overview
How to install
Federal Communications Commission (FCC) Compliance Notice : Radio
Frequency Notice – This equipment has been tested and found to comply with
the limits for a Class B digital device, pursuant to part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates, uses,
and can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not
occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures: Reorient or relocate
the receiving antenna. Increase the separation between the equipment and
receiver. Connect the equipment into an outlet on a circuit different from
that to which the receiver is connected. Consult the dealer or an experienced
radio/TV technician for help. Any modifications not approved by the
manufacturer of this device could void the user’s authority to operate this
device. Installation of a home and building automation and control system
shall comply with HD 60364-4-41. The temperature limits and current-carrying
capacities for the communication wires specified in HD 384.5.523 shall not be
exceeded.
www.lighting.philips.com/dynalite
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>