MIXTILE Blade 3 Delayed Cluster Box Installation Guide
- June 6, 2024
- MIXTILE
Table of Contents
MIXTILE Blade 3 Delayed Cluster Box
Thank you for purchasing Cluster Box. This guide is designed to guide you through installation.
Package list
Check the package and ensure that the following items are included.
If any item is missing or damaged, contact your sales representative for help:
Preparations
Besides the packaged items, you also need to prepare the following items for Cluster Box installation:
Installation Steps
Install Mixtile Blade 3 boards
- A. Loosen the two captive screws on the motherboard tray with the indication N1 by turning them counterclockwise. Then take out the motherboard tray.
- B. Use a Phillips screwdriver to loosen the four screws (two flat head screws + two M3*10 round head screws) that secure the heatsink to the motherboard tray. Push the heatsink outwards and remove the heatsink from the motherboard tray.
- C. Place the Blade 3 on the heatsink. Note that Blade 3’s MIPI CSI interface must face the heatsink’s notch and their screw holes line up.
- D. Attach Blade 3 to the heatsink. Install two M3*10 Phillips round head machine screws to the holes far away from the heatsink’s notch.
- E. Slide the combined unit into the motherboard tray. Reinstall the two flat head screws to secure the heatsink on the motherboard tray, and install two M3*5 Phillips round head machine screws to the screw holes near the heatsink’s notch.
- F. Place the assembled Blade 3 unit to the corresponding slot on Cluster Box and secure the two captive screws by turning them clockwise.
- G. Repeat steps (A) to (F) to install the other three Blade 3 boards in Cluster Box.
Connect power
Connect one end of the power adapter to the power port of Cluster Box and the
other end to a power source. You’ll notice that the LED lights up blue,
indicating that Cluster Box is powered on. By default, the Blade 3 boards are
powered on sequentially.
Connect to network
Connect the Ethernet cable to the RJ45 interface of Cluster Box.
Follow-up Procedure
Via GUI:
a. Enter the IP address of Cluster Box in your browser.
b. On the login page, retain the username mixtile and enter password mixtile.
Then you are directed to the GUI of Cluster Box.
Via SSH:
a. In the terminal, type ssh mixtile@Cluster Box IP address.
b. Type password mixtile and press Enter.
Install SSDs (Optional)
A. Open the rear cover of Cluster Box.
B. Install the SSD into the NVMe M.2 slot using M3*4 Phillips pan head machine
screws with washers.
Learn More
For more information, visit https://www.mixtile.com/ or scan the QR code
below.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>