THETFORD Cooker Triplex 700 Series Installation Guide
- June 6, 2024
- THETFORD
Table of Contents
- Introduction
- Symbols
- Regulations and standards
- Serviceability
- Before installation
- Position and placement
- Connecting gas
- Connecting electricity
- After installation
- Technical specifications
- Servicing
- Questions / customer service
- Customer Contact Us
- Read User Manual Online (PDF format)
- Download This Manual (PDF format)
**THETFORD Cooker Triplex 700 Series Installation Guide
**
Introduction
This is the installation manual for the Thetford SOH700, SOH710, SOH750, SOH760 and SOH770 series cooker. The manual is meant for qualified installers who will install the cooker in a caravan, camper, boat or holiday home. Read the in formation and instructions carefully and follow them strictly to install the cooker safely and correctly.
Also read the warnings in the user manual before testing the cooker after installation.
Our policy is one of continuous development and improvement. Specifications and illustrations may change subsequent to publication.
This document is version SINS2326/0521−V01 of the installation manual. Please visit www.thetford.com for the most recent version.
If the appliance is not installed in accordance with national and European regulations, rules and standards this will void the warranty and may lead to criminal prosecution.
Symbols
Key to symbols:
- Warning. Risk of injury and/or damage.
- Attention. Important information.
- Note. Additional information.
Regulations and standards
- Do not modify this appliance, unless the modification is authorised and carried out by the manufacturer or their agent.
- Use only genuine and approved parts and materials.
- Wear the correct Personal Protective Equipment during the installation. Also follow the applicable safety regulations.
- Gas and electrical appliances should only be installed by qualified and certified professionals.
- Ensure that the type of gas and pressure match the specification of the appliance. You can find the specification on the data badge.
- Pay close attention to current regulations on ventilation in the country of use. The installation must provide for adequate air supply for combustion to the burners, safe removal of combustion products and avoidance of accumulation of unburned gases.
- If it is not possible to install the appliance in accordance with these instructions, please refer to Thetford for further guidance.
- For more information about ventilation regulations and requirements, see Position and placement.
Serviceability
The installer of Thetford products is responsible for proper installation to ensure the correct functionality and serviceability of the appliance. In terms of serviceability, this means that a dealer or an authorised Thetford service partner must be able to remove and re−install the Thetford products within the time that is allowed according to the Thetford time−list, using standard tools and equipment.
This is to claim any warranty during the period of 3 years after purchase date. The serviceability of the product is also included in the audit. In case of any queries on this subject, please contact the Thetford local service representative before installing the product.
Before installation
Check the contents of the box:
- SOH700, SOH710, SOH750, SOH760 or SOH770 series cooker
- Grill pan
- Oven shelf
- User manual
- Installation manual
If something is missing from the box, please contact your dealer.
Position and placement
- Remove all packaging materials from the appliance.
- Check the opening where the appliance will be installed. The location must provide:
- Wood cabinetry
- Support for weight of at least 40kg (for the cooker and items placed inside)
- Grounded electrical outlet
- Minimum installation clearances for installation location (see images below)
- Mount the wood battens to both sides of the cabinet.
- Slide the appliance all the way into the opening
- SOH700−710−750: 445mm; SOH760−770: 496mm
- 10mm
- Wood batten SOH700−710−750: max. 15x40x330mm; SOH760−770: max. 14x40x330mm; to be fitted to both sides of the cabinet
- 17mm
- 463mm
- 37mm
- 493mm
- min. 80mm
- min. 10mm
The appliance must be positioned free from draughts, which may effect the combustion.
It must also be positioned in a manner that will prevent the accumulation of unburnt gas.
This appliance may be installed in a kitchen/kitchen diner but not in a room containing a bath or a shower. LPG appliances must not be fitted below ground level e.g. in a basement.
Follow the minimum dimensions shown in this manual. Any deviation could result in excessive temperature rise. If the minimum dimensions must be reduced, due to design constraints, a temperature rise test of all furniture fitted around the appliance must be performed. Where the minimum dimensions are reduced, it is recommended to install non−combustible material.
The surrounding surfaces must be able to withstand the allowable temperature rise oG 65ºC above ambient temperature, as specified in the EN30−1−1 standard and in accordance with the design of this unit.
All combustible materials such as curtains and shelves must be kept well clear of the appliance.
The temperature of the surrounding surfaces may rise if there are other additional devices besides the appliance. Check the allowable temperature of the materials used for the surrounding surfaces to ensure that they meet the requirements of EN30−1−1, EN1949, EN1645−1, EN1646−1, EN1647 and EN721.
- Fix the appliance in place using the fixing screw positions located on either side of the front trim assembly and to either side of the hob. Make sure the appliance is located correctly in the aperture prior to final fixing.
- Maintain the minimum distances between the cooking appliance and side, rear and overhanging parts.
- min. 500mm
- min. 500mm
- min. 400mm
- min. 10mm
- min. 200mm
- min. 200mm
If you are unable to maintain these minimum distances, protect with non−flammable material.
For models with a glass lid, the distance from the edge of the burner to the rear wall can be reduced to 110mm.
- Provide ventilation (A).
- Provide a gas dispersal hole to the outside (B).
To ensure correct operation the installation must allow for free exchange of air between the enclosure and the living environment.
Design constraints may dictate additional venting at the front off the installation.
Maintain provision for the dispersal of unburnt gas beneath the appliance. Ensure any gas dispersal hole (B), is located away from the oven burner.
To ensure correct operation and prevent changes in air pressure affecting appliance performance, the appliance must be built into a securely fixed self−contained cabinet which is not connected to externally vented chambers in adjacent furniture, other than the gas dispersal hole described above.
Connecting gas
- Connect the gas to the Ø 8mmgas inlet.
- Use only metal gas pipes in accordance with the requirements of EN1949.
Never use rubber tubing.
The burners have a fixed air/fuel mixture. When using propane, the flames burn quietly with a blue−green color and no yellow at the tip. With butane, the flames have yellow tips. The yellow color of the flames increases slightly as the burner heats up.
Connecting electricity
- Connect the 12V cables for cooling fans and spark ignition to a 12V DC battery using suitable connectors, observing the correct polarity.
Dual Fuel only:
- Models fitted with power cord only: This appliance is supplied with a double insulated cord, type 227 IEC 53, HO5VV−F, which has a current capacity of up to 4A. This should be connected to a double pole switched mains supply, with 3mm minimum contact separation at all poles in accordance with the wiring rules. The switch must be accessible after installation.
- Models fitted with Euro plug and power cord: This appliance is supplied with a Euro plug attached to the end of the power cord, for connection to a switched wall mounted socket. The switched socket must be accessible after installation.
- Rotary switch
- Warning lamp
- Hotplate numbers
- Hotplate
- Earth (hob)
- Earth (fascia)
- Cable clamp
This appliance must be earthed.
Ensure that all electrical cables are routed directly away and well clear of this appliance and other heat sources.
Do not allow the cord or wires to hang loose into the lower compartment.
After installation
- Ensure that all packaging materials have been removed.
- Fix a warning label next to the unit that meets the requirements of EN721, Annex A.
- Fix a warning notice next to the gas dispersal hole, with the text: Warning! Under no circumstances should the gas dispersal hole be obstructed.
- Test all gas piping and connections and make sure they do not leak
- Check the pressure of the gas when all connected gas appliances are in use simultaneously.
The gas pressure may not rise or Gall by more than 2.5mbar relative to the nominal value.
Technical specifications
Table 1: Burner speci1ications
SOH700 & SOH750 series | SOH760 series | |
---|---|---|
Gas input | Injector | |
**** | **** | **** |
kW | g/hr | mm |
Gas burners | 2 x 1.7 |
1 x 2.4
| 2 x 130
1 x 173
| 0.67
0.77
| 2 x 1.5
1 x 2.4
| 2 x 108
1 x 173
| 0.61
0.77
Oven burner| 1.6| 115| 0.59| 1.6| 115| 0.59
Grill burner| 1.6| 115| 0.62| 1.6| 115| 0.62
Total| 7.4| 548| | 7| 504|
| SOH710 series| SOH770 series
---|---|---
| Gas input| Injector| Gas input| Injector
| | | | |
kW| g/hr| mm| kW| g/hr| mm
Gas burners| 2 x 1.5| 2 x 108| 0.61| 2 x 1.5
1 x 1.0
| 2 x 108
1 x 72
| 0.61
0.52
Hotplate burner| 1 x 800W 230−240V ~ AC 50Hz| 1 x 800W 230−240V ~ AC 50Hz
Oven burner| 1.6| 115| 0.59| 1.6| 115| 0.59
Grill burner| 1.6| 115| 0.62| 1.6| 115| 0.62
Total| 4.6 (gas) 800W (electric)| 331| | 5.6 (gas) 800W (electric)| 403|
Table 2: Dimensions and weight
| SOH700 &
SOH750 series
| SOH710 series| SOH760 series| SOH770 series
---|---|---|---|---
Dimensions| H| W| D| H| W| D| H| W| D| H| W| D
mm| 468| 463| 500| 468| 463| 500| 468| 513| 500| 468| 513| 500
Appliance weight| 21.5kg| 23.1kg| 23.0kg| 24.6kg
Oven volume| 36L| 36L| 36L| 36L
Spark ignition| 12V DC| 12V DC| 12V DC| 12V DC
Table 3: Gas category
Class 3 Appliance
CAT I3 + (28−30/37)| CAT I3 B/P (30)
BUTANE (G30) 28 – 30mbar| BUTANE (G30) 30mbar
PROPANE (G31) 37mbar| PROPANE (G31) 30mbar
Use only the type of gas and the pressures specified.
Servicing
All servicing must be carried out by an approved competent person. Before any service work is started, the appliance should have been left to cool and be disconnected from both the gas and electrical supplies. After each service the appliance must be checked for gas soundness and electrical safety.
For service, please contact your authorised local Service Centre giving details of the model and serial number on the data badge plus date of purchase.
Questions / customer service
- Visit www.thetGord.com.
- Contact Customer Service Thetford in your country. See the addresses on the back.
Customer Contact Us
EUROPEAN HEAOOUARTERS Thetford B.V. Nijverheidsweg 29 P.O. Box 169 4870 AD
Etten-Leur
The Netherlands
T +3 1 Z6 504 22 00
F +3 1 7 6 504 23 00
E info@thetford.eu
UNITED KINGDOM Thetford Ltd. Unit 6 Brookfields Wag Manvers, Rotherham S63
SDL, England
United Kingdom
T +44 844 99 7 19 60
F +44 844 99Z 196 1
E infogb@thetford.eu
GERMANY Thetford GmbH Schallbruch 14 D-42781 Haan
Deutschland
T +49 2129 94250
F +49 2129 942525
E infod@thetford.eu
FRANCE Thetford S.A.R.L. Parc BUROPLUS / Bâtiment 6 18, Boulevard de la
Paix 95800 CERGY
France
T +33 1 30 37 58 23
F +33 1 30 37 9Z 6Z
E infof@thetford.eu
ITALY Thetford Italy c/o Tecma s.r.I. Via FlaminiaLoc. Castel delle
Formiche 05030 Otricoli (TR]
Italia
T +39 0Z44 Z0907 1
F +39 0Z44 719833
E infoi@thetford.eu
ITALY Thetford Italy c/o Tecma s.r.I. Via Flaminia Loc. Castel delle
Formiche 05030 Otricoli (TR]
Italia
T +39 0Z44 Z0907 1
F +39 0Z44 719833
E infoi@thetford.eu
SPAIN ANO PORTUGAL Mercé Grau Solá Agente para España q Portugal c/
Castellet, 36 bxs 2° 08800 Vilanova i la Geltrú Barcelona
España
T +34 938 154 389
F not available
E infosp@thetford.eu
SCANDINAVIA Thetford B.V. Representative 0Pice Scandinavia Hantverkaregatan
32D 521 61 Stenstorp
Sverige
T +46 31 336 35 80
F +46 31 44 85 70
E infos@thetford.eu
AUSTRALIA Thetford Australia Pty. Ltd. 130-132 Freight Drive Somerton, VIC
3062
Australia
T +61 3 9358 0700
E infoaus@thetford.com.au
www.thetford.com.au
CHINA Thetford China Rm. 1207, Coastal Building [East Block] Haide 3rd
Road, Nanshan District Shenzhen, 518054
China
T +86 755 862Z 1393
F +86 CSS 862Z 1673
E info@thetford.en
www.thetford.en
® Copyright 2011-202 1 Thetford B.V. All rights reserved.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>