THETFORD C223CS Cassette Toilet User Manual
- June 1, 2024
- THETFORD
Table of Contents
- C223CS Cassette Toilet
- Introduction
- Symbols
- Main components
- Before use
- Use of the toilet
- Emptying the waste-holding tank
- [Emptying the flush-water tank (C224-CW/C222-SWE]](#Emptying+the+flush-water+tank+%28C224-CW%2FC222-SWE%5D)
- Maintenance and cleaning
- Winter use
- Troubleshooting
- Servicing
- Putting in storage
- Questions
- Warranty
- References
- Read User Manual Online (PDF format)
- Download This Manual (PDF format)
Cassette Toilet
C220 Series
User Manual
C223CS Cassette Toilet
TAKE CARE, TAKE THETFORD
World’s best selling toilet additives
We: THETFORD B.V.
Address: Nijverheidsweg 29, 4879 AP, Etten-Leur, Netherlands
Telephone: +3176 5042 200 Fax: 431 76 5042 300
Declare that
Product Types; Cassette toilet
Model Number/Description; C220 Series.
Satisfies the essential requirements of the following directives:
– 2011/65/EU RoHS 2
– Automotive EMC Directive 2004/104/EC
Based on the following standards applied:
– EN 50498:2010 EMC aftermarket Electronic equipment in vehicles
The products concerned have no immunity related functions in accordance with
the Automotive EMC Directive 2004/104/EC
Name : S.P. Cordeille
Title/Position : Chief Executive Officer
Place & Date of Issue : Etten-Leur, 12 February 2016
Signature
Declartion of Conformity C220 Seres, Februory 2016
Introduction
This is the user manual for your Thetford toilet. Read the safety instructions
and information on use and maintenance of the toilet carefully before
continuing. This will enable you to use the toilet safely and efficiently.
Retain this manual for future reference.
For the latestversion of this manual, please visit
www.thetford.com.
Symbols
Key to symbols:
Warning. Risk of seriousinjury and/or damage.
Caution. Risk of injury and/or damage.
Attention. Importantinformation.
Note. Information.
Main components
See the image in the fold-out cover for a visual reference.
A. Toilet
B. Waste-holding tank (18L)
-
Level indication
-
Console (C223-CS)
Flush-water tank (C224-CW/C222- SWE) -
Control panel*
-
Cover
-
Seat
-
Swivelling toilet bow!
-
Blade handle
-
Float
-
Pour out spout
-
Cap
-
Automatic pressure release vent
-
Wheel
-
Pull handle
-
Vent button
-
Sliding cover
-
Blade opener
*The image shows the 223-CS, which features a flush button on the control panel on the console to flush the toilet.
The C223-5/C223-CS uses the central water tank of the vehicle to flush. The
C224-CW/ C222-SWE have a flush-watertank.
The C224-CW features a flush handle on the console to flush the toilet.
The C223-S and C222-SWE feature a flush button on the control panel on the
wall to flush the toilet.
Acassette toilet is not connected to a central sewage. This toilet has an
integrated sewage system (B), which you need to empty when full.
Before use
See theimages in the fold-out cover for a visual reference.
-
Ensure that all packaging materials have been removed.
Prepare the waste-holding tank: -
Remove the waste-holding tank through the service door (01).
-
Place the waste-holding tank upright and turn the pour out spout upwards.
-
Remove the cap from the pour out spout (02).
-
Check the correct dosage of Thetford waste-holding tank additive on the package.
-
Add the stated dosage to the waste-holding tank (03).
-
Add ±3L of water to the waste-holding tank to ensure that the bottom of the waste-holding tank is covered (03).
-
Screw the cap back onto the pour out spout.
-
Slide the waste-holding tank back into its original position via the service door (04).
Prepare the flush-water tank (only for C224-CW and C222-SWE): -
Check the correct dosage of Thetford flush-water tank additive on the package.
-
Add the stated dosage to the flush-water tank through the waterfill door (05).
-
Fill the flush-water tank with clean water through the waterfill door, using a jerry can or hose (05).
Not using Thetford products to care for your Thetford tailet could cause
damage.
Never add toilet additives directly via the valve blade or via the toilet bowl
as this could damage the lip seal of the waste-holding tank. Only fill the
waste-holding tank via the pour outspout.
Never use force if you cannot get the waste-holding tank back into place
easily. If blockage occurs, always checkifthe blade handle is in the closed
position.
Check after storage:
- After storage, check the water installation on damages before filing the systemwith water again.
- After filling the system, check ifflush s present and make sure there are no leakages.
Use of the toilet
The toilet can withstand a maximum load of 120kg. Make sure you do not
overload the toilet.
See the images in the fold-out cover for a visual reference.
Turning the toilet bowl:
- Close the cover and use both hands to rotate the bowl to the desired position (max. 90° clockwise and 170° counterclockwise) (06).
Opening the blade:
- Open the blade by moving the blade handle from left to right (07).
- Always close the blade completely after use.
The toilet can be used with the blade open or closed.
Flushing the toilet:
- Make sure the blade is open.
For 223-5/C223-CS/C222-SWE:
- Press the flush button and hold it for several seconds to flush the toilet (08).
For C224-CW:
- Move the flush handle up and down to flush the toilet (09).
- Close the blade after flushing.
Ordinary toilet paper can cause clogging. Use Thetford Aqua Soft tailet paper
for your tailet. Thistoilet paper is super-soft, dissolves quickly, prevents
clogging and makes it easier to empty the waste-holding tank.
For (223-5/C223-CS/C222-SWE: The flush of your toiletwill be more effective if
you pulsate the flush by pressing the flush button several times in a row.
To prevent waterdamage to yourcaravan or motor home, do not travel with
waterin the toilet bowl.
Do not leave water in the toilet bowl if the toilet is not being used. This
does not help to reduce unpleasantsmells and only leads to flooding.
Emptying the waste-holding tank
See the images in the fold-out cover for a visual reference.
Your toilet has a 1-level indication for the waste-holding tank. When the
slide tums from green to red, the waste-holding tank s full.
Emptying the waste-holding tank:
- Remove the waste-holding tank (01).
- Fold out the pull handle until it is fully extended.
- Pull the tank to an authorised waste disposal point (10).
- Place the waste-holding tank upright and turn the pour out spout upwards.
- Remove the cap from the pour out spout (02).
- Press and hold the vent button with your thumb while the pour out spout is pointing downwards to empty the waste-holding tank (11).
- Add ±5L of water to the waste-holding tank and replace the cap (12).
- Gently shake the tank to clean it (13). Empty the waste-holding tank again (11).
- Remove the float from the waste-holding tank by turning it clockwise and rinse the float with tap water (14).
- Fold in the pull handle until it clicks into place.
- Slide the waste-holding tank into the toilet and close the service door (04).
- If youwant to continue using your toilet after emptying the waste-holding tank, prepare the waste-holding tank again. See Before use.
To prevent water damage to your caravan ormotor horne, do not travel with a
waste- holding tank that is more than 3/4 ful. This may cause leakage through
the venting system.
Do not allow the waste-holding tank to become too full.
Thetford green toilet additives are completely safe to empty into a septic
tank or small biological systems on camping sites. b
Emptying the flush-water tank (C224-CW/C222-SWE]
See the images in the fold-out cover for a visual reference.
Only empty the flush-water tank completely if you expect not to use your
tailet for a long period.
Emptying the flush water tank:
- Place a sufficiently large bowl underthe drain tube.
- Open the drain tube and catch the remaining water in the bowl (15).
- Empty the bowlat an authorised waste disposal point.
To prevent water damage to your caravan or motor home, do not travel with a flush-water tank that is too full. Thetford advises travelling with an empty flush-water tank, but at least not filled more than half-full.
Maintenance and cleaning
See the images in the fold-out cover for a visual reference. Also see the
inside cover for an overview of the additives which need to be used.
Thetford recommends cleaning your tailet regularly to prevent limescale and
ensure optimal hygiene.
- Clean the inside of the bowl with Thetford Toilet Bowl Cleaner and a soft brush.
- Clean the outside of the bowl with Thetford Bathroom Cleaner.
- Remove the seat and cover to clean your toilet thoroughly. To o this, push the seat and cover together to the right, then lift them up.
- Remove the float from the waste-holding tank and rinse it with tap water (04).
Never use household cleaners to clean your toilet. These may cause permanent damage tothe seals and other toilet components. For example, the use of liquid bleach could lead to discoloration.
Thetford recommends maintaining your toilet regularly to prolong the lifespan of your talet.
- Use Thetford Cassette Tank Cleaner 2 to 3 times a year on the waste-holding tank to remove stubbom limescale on the inside of the tank.
- Use Thetford Seal Lubricant to keep the seals softand pliable. It has been specially developed for mobile toilets and is absolutely safe to use.
Never use Vaseline orvegetable oil to lubricate the seals. This may cause
leakage to your waste-holding tank.
The blade seal is a part of the toilet thatis subject to wear. Depending on
the extent and manner of servicing, after a certain period the seal will lose
quality and must be replaced.
Winter use
You can use your toiletas normal in cold weather as long as the toilet is situated in a heated location. If this is not the case, and there is a risk of frost, we advise not to use your toilet. Make sure you completely drain the toilet and the water system of the vehicle. Then empty the waste-holding tank and the flush-water tank (if applicable), see Putting in storage.
Troubleshooting
Problem | Possible cause | Solution |
---|---|---|
Waste−holding tank cannot be removed | Blade is (partly) open | Fully close the |
blade
Blade does not move| Blade is blocked| Loosen cap Grom pour out spout
Level indication waste−holding tank does not work| Mechanism level indication
in waste−holding tank is stuck| Remove mechanism Grom waste−holding tank and
rinse it with tap water
Waste−holding tank leaks| Seal is dry Seal is worn| Spray seal with seal
lubricant Replace seal
If you cannot solve a problem, contact the authorised local Service Centre or Thetford Customer Service in your country,
Servicing
All servicing must be carried out by an approved competent person.
For service, please contact your authorised local Service Centre giving
details of the model and serial number on the data badge plus date of
purchase.
The data badge can be found on the base of the toilet.
Putting in storage
- Empty the flush-water tank (dependent on model) and the water system of the vehicle.
- Push the flush button until no flush-water s visible.
- Empty the waste-holding tank.
- Thoroughly clean and dry the whole toilet.
- Open the blade and loosen the cap of the pour out spout to ventilate the waste-holding tank.
- We recommend maintaining your toilet before putting it into storage. Referto Maintenance and cleaning
Questions
If you have questions about your product, parts, accessories or authorised services:
- Visit www.thetford.com.
- If you cannot solve a problem, contact the authorised local Service Centre or Thetford Customer Senice in yourcountry,
Warranty
For ourwarranty clause, please refer to the conditions mentioned on www .thetford-europe.com/service/warranty. For more information, please contact the Thetford Customer Service in your country.
EUROPEAN HEADQUARTERS
Thetford BV
Nijverheidsweg 29
PO. Box 169
4870 AD Etten-Leur
The Netherlands
T+3176 5042200
F+3176 5042300
E info@thetford.eu| UNITED KINGDOM
Thetford Ltd
Unite
Brookfields Way
Manvers, Rotherham
63 50L, England
United Kingdom
T+44.844997 1960
F+44844997 1961
E infogb@thetford.eu| GERMANY
Thetford GmbH
Schallbruch 14
D-42781 Haan
Deutschland
T+49 212994250
F+49 2129942525
E infod@thetford.eu
FRANCE
Thetford SARL.
Parc BUROPLUS /Batiment 6
18, Boulevard de la Paix
95800 CERGY
France
1+33130375823
F+33130379767
E infof@thetford.eu| ITALY
Thetford Italy /o Tecma s.rl.
Via Flaminia
Loc. Castel delle Formiche
05030 Otricoli (TR)
Italia
T+390744 709071
F+390744 719833
E infoi@thetford.eu| SPAIN AND PORTUGAL
Mercé Grau Sola
Agente para Espafia y Portugal
o Castellet, 36 bxs 2*
08800 Vilanovai la Geltri
Barcelona
Espaia
T+34938154 389
Frotavailable
E infosp@thetford.eu
SCANDINAVIA
Thetford BV
Representative Office Scandinavia
Hantverkaregatan 32D
52161 Stenstorp
Sverige
T+46 31336 3580
F+46 31448570
E infos@thetford.eu| AUSTRALIA
Thetford Australia Pty. Ltd.
41 LaraWay
Campbellfield VIC 3061
Australia
T+61393580700
F+6139357 7060
E infoau@thetford.eu
www.thetford.com.au| CHINA
Thetford China
Rm. 1207, Coastal Building
(EastBlock)
Haide 3rd Road, Nanshan District
Shenzen, 518054 China
T+86 7558627 1393
F+86 7558627 1673
E info@thetford.cn
www.thetford.cn
200703/0918-V04.
©Thetford 2018
www.thetford.com
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>