Megagain 5785-V Disney 9inch Mickey Mouse Fire Truck RC Vehicle Instructions

Megagain 5785-V Disney 9inch Mickey Mouse Fire Truck RC Vehicle

BATTERY SAFETY INFORMATION

1. DO NOT MIX OLD AND NEW BATTERIES
2. DO NOT MIX ALKALINE, STANDARD (CARBON-ZINC), OR RECHARGEABLE (NICKEL-CADMIUM) BATTERIES.
3. ONLY BAITTRIES OF THE SAME OR EQUIVALENT TYPE AS RECOMMENDED ARE TO BE USED.
4. BATTERIES ARE TO BE INSERTED WITH THE CORRECT POLARITY.
5. EXHAUSTED BATTERIES ARE TO BE REMOVED FROM THE PRODUCT.
6. REMOVE BATTERIES IF PRODUCT IS TO BE LEFT UNUSED FOR A LONG TIME.
7. THE SUPPLY TERMINALS ARE NOT TO BE SHORT-CIRCUITED.
8. NON-RECHARGEABLE BATTERIES ARE NOT TO BE RECHARGED.
9. RECHARGEABLE BATTERIES ARE TO BE REMOVED FROM THE PRODUCT BEFORE BEING CHARGED
10. RECHARGEABLE BATTERIES ARE ONLY TO BE CHARGED UNDER ADULT SUPERVISION
11. DISPOSE OF BATTERY(IES} SAFELY.
12. DO NOT DISPOSE OF THIS PRODUCT IN A FIRE. THE BATTERIES INSIDE MAY EXPLODE OR LEAK
13. BATTERIES SHOULD BE CHARGED BY ADULTS ONLY.

VEHICLE OPERATION

ANY OF THE FOLLOWING CONDITIONS MAY INTERFERE WfTH THE BEHAVIOR AND FUNCTION. THE TRANSMITTER SIGNALS CAN EASILY BE INTERRUPTED.
IMPROPER HANDLING MAY HAMPER THE PERFORMANCE OF THE VEHICLE.

SAFETY PRECAUTIONS

REMEMBER TO AVOID WATER, HEAT, SAND AND HIGH IMPACT!

1. KEEP VEHICLE AWAY FROM WET SURFACES OR RAIN.
2. AVOID RUNNING ON THICK CARPETS OR DUSTY FLOORS.
3. AVOID COLLISIONS ON HARD SURFACES
4. KEEP VEHICLE AWAY FROM SANDY OR DUSTY AREAS.
5. DO NOT OPERATE YOUR VEHICLE ON THE STREETS!

CAUTION

CHANGES OR MODIFICATIONS TO THIS UNIT NOT EXPRESSLY APPROVED BY THE PARTY RESPONSIBLE FOR COMPLIANCE COULD VOID THE USER’S AUTHORITY TO OPERATE THE EQUIPMENT.

NOTE:
THIS EQUIPMENT HAS BEEN TESTED AND FOUND TO COMPLY with THE LIMITS FOR A CLASS B DIGITAL DEVICE, PuRSIJANT TO PART 15 OF THE FCC RULES. THESE LIMITS ARE DESIGNED TO PROVIDE REASONABLE PROTECTION AGAINST HARMFUL INTERFERENCE IN A RESIDENTIAL INSTALLATION
THIS EQUIPMENT GENERATES, USES AND CAN RADIATE RADIO FREQUENCY ENERGY AND, IF NOT INSTALLED AND USED IN ACCORDANCE WITH THE INSTRUCTIONS, MAY CAUSE HARMFUL INTERFERENCE TO RADIO COMMUNICATIONS.
HOWEVER, THERE IS NO GUARANTEE THAT INTERFERENCE Will NOT OCCUR IN A PARTICULAR INSTALLATION.
IF THIS EQUIPMENT DOES CAUSE HARMFUL INTERFERENCE TO RADIO OR TELEVISION RECEPTION, WHICH CAN BE DETERMINED BY TURNING THE EQUIPMENT OFF AND ON, THE USER IS ENCOURAGED TO TRY TO CORRECT THE INTERFERENCE BY ONE OR MORE OF THE FOLlOWING MEASURES:

• REORIENT OR RELOCATE THE RECEIVING ANTENNA.
• INCREASE THE StPARATION BETWEEN THE EQUIPMENT AND RECEIVER CONNECT THE EQUIPMENT INTO AN OUTLET ON A CIRCUIT DIFFERENT FROM THAT TO WHICH THE RECEIVER IS CONNECTED.
• CONSULT THE DEALER OR AN EXPERIENCED RADIOnv TECHNICIAN FOR HELP

THIS DEVICE CONTAINS LICENSE-EXEMPT TRANSMlffiR(S)/RECEIVER{S} THAT COMPLY WITH INNOVATION, SCIENCE AND ECONOMIC DEVELOPMENT CANADA’S LICENSE-EXEMPT RSS(S). OPERATION IS SUBJECT TO THE FOLlOWING TWO CONDmONS:
(1) THIS DEVICE MAY NOT CAUSE INTERFERENCE.
(2) THIS DEVICE MUST ACCEPT /.IN INTERFl’RENCE INCLUDING INTERFERENCE THAT MAY CAUSE UNDESIRED OPERATION OF THE DEVICE
” THIS DEVICE ANO ITS ANTENNA MUST NOT BE CO-LOCATED OR OPERATING IN CONJUNCTION WITH ANY OTHER ANTENNA OR TRANSMlffiR. THIS RADIO COMMUNICATION DEVICE COMPLIES WITH ALL THE REQUIREMENTS OF INDUSTRY CANADA STANDARD RSS-210.

Disposal

Rf.QUIRES 4 X M (LR6J ANO 1 X fJv (6LR61) ALIW.INE BATTERIES (NOT INQUOED), BATTERIES OR BATTERY PACKS MUST BE RECYCLED OR DISPOSED OF PROP’i:RlY, WHEN THIS PRODUCT HAS REACHED THE ENO OF ITS USEFUL LIFE IT SHOllD NOT BE DISPOSED OF WITH OTHER HOI.JSEl,OlD WASTE. Tff WASTE ELECTRICAL AND ELECTRONIC EQUIPMENT RE!locations REQUIRE IT TO BE SEPARATELY COLLECTED SO THAT IT CNl BE TREATED USING THE BEST AVAILABLE RECOVERY ANO RECYCLING TECHNIQUES

THIS Will MINIMIZE THE IMPACT ON THE environment AND HUMAN HEALTH FROM SOIL AND WATER CONTM4INATION BY ANY HAZARDOUS SUBSTANCES, DECREASE THE RESOURCES REQUIRED TO MAKE NEW PRODUCTS ANO AVOID USING UP l..AfJORLL SPACE, PLEASE DO YOUR PART BY KEEPING THIS PRODUCT OUT OF TI-( MUNICIPAL.. WASTE STREAM! THE ‘WHEELIE BIN’ SYMBOL ME.AND THAT IT SHOULD BE COLLECTED AS ‘WASTE ELECTRICAL.. ANO ELECTRONIC EQUIPMENT.’ YOU CAN RffilRN AN OlD PRODUCT TO YOUR RETAILER WHEN YOU BUY A SIMllAR NEW ONE. FOR OTHER OPTIONS, PLEASE CONTACT YOUR LOCAL COUNCIL

BATTERY INSTALLATION VEHICLE

BATTERY INSTALLATION CONTROLLER

HOW TO PAIR THE CONTROLLER TO THE VEHICLE BEFORE PLAY

HOW TO PAIR

1. INSERT BATTERIES {CAR MD CONTROLLER)
2. lllRN CAR & CONTROLLER SWITCH TO woN.”
3. PRESS ANY BUTTON ON THE CONTROLLER FOR 2 TO 3 SECONDS,
4. PAIRING SHOULD BE SUCCESSFUL.
5. IF YOU NEED TO PAJR MORE CARS WITI–l SEPARATE CONTROLlERS AT THE SAME TIME, THEY MUST BE PAIRED 3 METERS APART FROM EACH OTHER.

HOW TO RESET PAIRING

1. TURN CAR & CONTROLLER SWITCH TO “OFF.”
2. learn CAR & CONTROLLER SWITCH TO “ON” AFTER 2 TO 3 SECONDS
3. PRESS Ar-N BUTTON OF THE CONTROLLER FOR 2 TO 3 SECONDS
4. PAIRING SHOULD BE SUCCESSFUL,

USING THE CONTROLLER

FORWARD
PRESS TOP ARROW BUTTONS “1” AND “3” AT THE SAME TIME TO WHEELIE/ MOVE FORWARD.

REVERSE
PRESS BOTTOM ARROW BUTTONS “2” ANO “4” AT THE SAME TIME TO REVERSE.

SPINNING
PRESS ARROW BUTTONS “1” AND “4” TO MOVE FORWARD/ SPIN LEFT.

PRESS ARROW BUTTONS “2” AND “3” TO MOVE FORWARD/ SPIN RIGHT.

TURNING

• PRESS THE ARROW BUTTON “1” TO MOVES FORWARD/TURNS LEFT.
• PRESS ARROW BUTTON “3” TO MOVES FORWARD/TURN RIGHT.
• PRESS ARROW BUTTON “2” TO MOVES IN REVERSE/TURNS LEFT.
• PRESS ARROW BUTTON “4” TO MOVES IN REVERSE/TURNS RIGHT.

Read User Manual Online (PDF format)

Download This Manual (PDF format)

Download this manual  >>