NAVITEL XR2600 Pro Dashcam with Radar Detector User Manual

NAVITEL XR2600 Pro Dashcam with Radar Detector

Introduction

Dear Customer!
Thank you for purchasing this NAVITEL® product.
NAVITEL XR2600 PRO − is a multifunctional DVR with GPS informer and radar detector. Please read the manual carefully before using the device and keep it for future reference.

Device layout

1. Mount with GPS antenna
2. Power connector
3. Button Reset
4. Button Protect
5. Button Up
6. Button Menu
7. Button Down
8. Display
9. Proximity sensor
10. Button Power
11. Rearview camera port (CAM-IN)
12. Speake
13. Lens
14. Radar detector receiver
15. Button Brightness
16. Button OK
17. Button Mode
18. MicroSD slot

Package contents

• DVR radar detector NAVITEL XR2600 PRO
• Mount with GPS antenna
• Car charger 12/24 V
• Micro-USB -USB cable
• Polarizing filter
• Microfiber cloth
• User manual
• Warranty card
• Gift voucher
• Card reader

* Note: Rearview camera is not included in the package.

Specification

Ка-band     34.700 GHz±1300 MHz Laser emission 800-1100 nm
Language| Russian/English/Ukrainian*

Note:

• Package contents, appearance, technical specifications, which do not affect the overall functionality of the device, are subject to change due to updates without prior notice.
• The built-in battery is designed only for recording an emergency event in parking mode and turning off the device correctly when the power is turned off; for the full operation of the device in any mode, a constant power connection is required.
  *Languages of the interface and voice messages become available as  result of firmware update.

STARVIS and  are trademarks of Sony Corporation.

Installation

1. Put the microSD card into the DVR. Use a high-speed SD card (Class U3 or above); capacity should be within 8-64 GB.
   |

   • To avoid malfunctions of the DVR and / or SD-card, don’t insert and remove SD-card during DVR operation.
   • Before using a microSD card, please format it inside the DVR to avoid data errors. For formatting the SD-card in Menu mode select Format SD-card and confirm it.
     ---|---

2. Secure the DVR on the windshield with the mount.

3. Connect the car charger to the cigarette lighter socket.

4. Connect the car charger to the GPS antenna input .

5. Adjust the camera position.

6. Turn the power on; check whether the device is installed correctly. If the device is installed correctly, the indicator will glow red; the device will start up and begin recording (indicated by flashing blue light).

Precautions

• Use only the original charger adapter. Using another adapter may negatively affect the device’s battery. Use accessories only approved by manufacturer.
• Permissible ambient temperature in operating mode: 0 to +35 °С. Storage temperature: +5 to +45 °С. Relative humidity: 5% to 90% without condensation (25 °С).
• Put the device away from fire sources to avoid explosion or fire.
• Do not expose the device to physical impacts.
• Avoid contacting the device with sources of electromagnetic radiation.
• Keep the lens clean. Do not use chemicals or detergents to clean the product; always turn off the device before cleaning.
• Strictly follow the laws and regulatory acts of the region where the device is used. This device can not be used for illegal purposes.
• Do not disassemble or repair device by yourself. In case of device failure, contact the service center.

Buttons

Button

|

Functions

---|---
| Click to turn on the device.
Press and hold for 2 seconds to turn off the device.
When the device is operating, press briefly to turn on / off the display.
| Press briefly to adjust brightness.
Press and hold to to turn the microphone on / off.

Video recording ( ОК )

| In Record mode , press to start recording; press again to stop recording. Press to turn on WI-FI.
In Menu, press to select menu item.
In the menu, hold down to hide the recording interface.

C/H

| Press, to change the operating mode of the radar detector.

М

| In Record mode, press to enter Menu mode.
In Record mode, press to enter Playback mode.
In the main menu, press briefly to select a menu item
In the subsections of the menu, press briefly to exit without saving changes. In Playback mode, press briefly to switch between files.
In Playback mode, hold down to delete the current file.  While watching a video, press briefly to return to the playlist.

▲

| In Video Recording mode, press briefly to adjust the volume. When the Radar detector is triggered, press to turn off the signal. Press briefly to move up in Menu and Playback mode.

▼

| In Record mode, press briefly to to turn the microphone on / off.

Lock

| In Record mode, press briefly to lock a file (protected file cannot be deleted or overwritten). In Capture mode, press and hold to take a picture.
In Playback mode, press to lock the file; hold down the button to unlock.
In Playback mode, press briefly to enter Record mode, then hold to take a photo.

Proximity sensor

| Wave your hand in front of the proximity sensor area to disable / enable sound alerts. To turn the display off / on, cover the sensor with your hand for a few seconds.

Note: The control buttons are located on both sides of the device. The setting selection keys are on the right side, the confirmation key on the left.

Device functions

Format SD-card| Formatting a microSD card in the DVR is necessary for the correct operation of the device. Before using a microSD card or in case of data error, please format the microSD card. For formatting the SD-card in Menu mode select Format SD-card and confirm it.
---|---
Record| Connect the device to an external power supply and it will start recording automatically (indicated by the flashing blue light). Press the OK button to stop recording. Press OK again to record another video. Each video will be saved automatically.
Capture| In Record mode, press the Lock button to take a photo (it will be saved automatically).
Playback| Press М to enter Playback mode; press the Up and Down buttons to select a file; press ОК button to play a file. During playback, press ОК to pause/unpause.
Protect file| In Record mode, press the Lock button to lock / unlock current file. Protected files cannot be deleted or overwritten. In Playback mode, select file, then press the Lock button to lock / unlock file.
Loop recording| This feature allows you to save a video as a set of files given in the duration menu. If the memory card runs out of space, the unprotected files will be overwritten in the order in which they were created.
Record audio| Record video with or without sound.
Stamp| This function adds date stamp to the record.
License plate| Using this function, you can add a stamp with the license plate of the vehicle to the video.
G-sensor| If the vehicle is hit by something, the DVR will automatically lock the current video.
Motion detection| When an object is moving the device will automatically start recording. If the object does not move for more than    60 seconds, recording stops.
View media| You can view files from the memory card of the DVR only using the built-in media player of the device, or using a card reader on a personal computer.

Digital Speed & Camera Info

The Digi t al speed feature is used to display time and vehicle speed calculated with the help of GPS signal. Modes:

• Speed – current speed is displayed constantly [ B ],
• Speed + time – current speed [ B ] and time [ C ] are displayed.

The Camera info feature notifies the driver about cameras and warnings (hereinafter – Cameras) along the way. When you turn on the Camera info, the current speed and time are displayed. With the approach to the nearest camera the following information is displayed:

• current speed [ B ],
• camera type [ D ],
• dynamic progress bar indicating approach to the nearest camera [ E ],
• distance to the camera [ F ].

All information is displayed on a black screen.
In Record mode (REC), •REC or • are displayed [ A ].
If the vehicle is still, 0 is displayed.
If there is no GPS-signal, – – – [ G ] is displayed.
Note. A weak GPS signal may be caused by bad weather conditions and other external factors. Please consult your vehicle speedometer.

Radar detector

When a signal is detected by a radar detector, the display shows information about the range [ I ] or type of radar (signature) and signal strength [ i ]. In order to turn off / turn on the alert sound, you must hold your hand in front of the device. To switch between the operating modes of the radar detector, press the C/H button.
By default, the Highway operating mode is set.

Parameters of the radar detector operating modes

Mode

| Х| K| Ka| Laser| CT|

Signature radar

---|---|---|---|---|---|---

Highway

| On| On| Off| On| On| On
City 1| On ≥3| On ≥2| Off| On| On|

On Band – K Band – X
Laser emission

City 2

| Off| Off| Off| On| On| Off
Signature*| Off| Off| Off| Off| On|

On

• Signature mode – the technology used by the radar detector to distinguish between speed meters and sources of interference.

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>