iHOME iCVBT500 Hollywood Studio XL Vanity Mirror User Guide
- June 6, 2024
- iHome
Table of Contents
iHOME iCVBT500 Hollywood Studio XL Vanity Mirror
What’s In the Box
Getting Started
Connect included AC adapter to DC jack on back of mirror and the other end to a working wall outlet not controlled by a light switch.
Charging Devices
The mirror MUST be connected to power for USB charging from the unit. This
unit includes 2 standard USB ports for charging devices.
Connect a USB-A charging cable (not included) to a USB port on the side of the
mirror, and connect the other end to your device to charge.
Light Function
• Press and hold the Light Button to adjust the lighting mode: Soft Yellow,
Warm White, or Bright White
• Press and release the Light Button to select a brightness level:
6/5/4/3/2/1/OFF
Accessories
Removable Detail Mirror
The back of the 10x magnifying detail mirror has SimpleStick™ micro suction
material for easily attaching and detaching almost anywhere on non-porous
surfaces. If necessary, clean SimpleStick material with office tape.
Removable Phone Holder
The rotating phone holder has SimpleStick™ micro suction material for easily
attaching and detaching almost anywhere on non-porous surfaces. If necessary,
clean SimpleStick material with office tape.
Cleaning Cloth
Use the included cleaning cloth to keep the large surface and detail mirror
smudge-free.
Bluetooth Audio Function
Voice control requires an active internet connection on connected
Bluetooth device with iOS 10 and Android 4.1 and later. When activated, the
speaker microphone acts as an extension of the microphone in your smartphone
to make/take calls, enable you to ask Siri®/Google Assistant™ to play music
and more.
MAINTENANCE
- Place the unit on a level surface away from sources of direct sunlight or excessive heat.
- Protect your furniture when placing your unit on a natural wood and lacquered finish. A cloth or other protective material should be placed between it and the furniture.
- Clean your unit with a soft cloth moistened only with mild soap and water. Stronger cleaning agents such as thinner or similar materials can damage the surface of the unit.
- This mirror comes with a cleaning cloth to keep the large surface and detail mirror smudge-free.
- Wash the mirrors with mild soap and water as needed.
- Micro-suction (for 10x Detail Mirror or Removable Phone Holder) – to restore suction, use water (preferably with soap), wipe off any debris, and allow to air-dry before use to restore easy attachment again.
IMPORTANT SAFETY INSTRUCTIONS
Please heed all warnings, read and follow all instructions and keep these instructions handy for future reference.
-
Do not use this product near water.
-
Unplug unit and clean only with damp cloth. Stronger cleaning agents, such as Benzene, thinner or similar materials can damage the surface of the unit.
-
Do not block any ventilation openings. Install in accordance with the manufacturer’s instructions.
-
Heat – This product should be situated away from heat sources such as radiators, heat registers, stoves or other appliances (including amplifiers) that produce heat.
-
Only use attachments/accessories specified by the manufacturer.
-
Unplug this product during lightning storms or when unused for long periods of time.
-
Damage Requiring Service – This product should be serviced by qualified service personnel when:
The plug has been damaged.
Objects have fallen into or liquid has been spilled into the enclosure.
The unit has been exposed to rain. The unit has been dropped or the enclosure damaged.
The unit exhibits a marked change in performance or does not operate normally. -
No naked flame sources, such as lighted candles, should be placed on this product.
-
Attention should be drawn to the environmental aspects of battery disposal.
-
This product is suitable for use in tropical and/or moderate climates.
WARNING:
- To reduce the risk of fire or electric shock, do not expose this product to rain or moisture.
- Do not dispose of batteries in the household trash or fire.
- The mains plug of power adaptor is used as the disconnect device, it shall remain readily operable.
- Sunlight: Never place the mirror in or expose the mirror to direct sunlight. The sun’s rays can reflect to become focused and cause excessive heat and/or fire. Do not use mirror in direct sunlight as reflected sunlight could injure eyes
FCC INFORMATION
This equipment complies with FCC RF radiation exposure limits set forth for an
uncontrolled environment.
This device complies with Part 15 of the FCC Rules, operation is subject to
the following two conditions:
(1) This device may not cause harmful interference, and (2) this device must
accept any interference received, including interference that may cause
undesired operation.
• Warning: Changes or modifications to this unit not expressly approved by the
party responsible for compliance could void the user’s authority to operate
the equipment.
• NOTE: This equipment has been tested and found to comply with the limits for
a Class B digital device, pursuant to Part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates, uses and
can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio
communications.
However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful interference to
radio or television reception, which can be determined by turning the
equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to
which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
This equipment should be installed and operated with minimum distance 20cm
between the radiator & your body.
ISED Information
This equipment complies with IC RSS-102 radiation exposure limits set forth
for an uncontrolled environment.
This device contains licence-exempt transmitter(s)/receiver(s) that comply
with Innovation, Science and Economic Development Canada’s licence-exempt
RSS(s). Operation is subject to the following two conditions:
(1) This device may not cause interference.
(2) This device must accept any interference, including interference that may
cause undesired operation of the device.
The device comply with ISED RF exposure requirement, users can obtain Canadian
information on RF exposure and compliance.
This equipment should be installed and operated with a minimum distance of 20
cm between the radiator and your body.
Any Changes or modifications not expressly approved by the party responsible
for compliance could void the user’s authority to operate the equipment.
WARRANTY
For product support information and warranty please visit:
www.ihome.com/support © 2021 SDI Technologies,
Inc. All rights reserved Questions? Visit
www.ihome.com
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>