SUPERSONIC 893LM Remote Control Instructions
- June 6, 2024
- Supersonic
Table of Contents
SUPERSONIC 893LM Remote Control Instructions
For use with Security+ 2.0™ products All Security+ 2.0™ Garage Door Openers have a yellow Learn button and two yellow antennas. The code between the remote control and the receiver changes with each use, randomly accessing aver a billion new codes. Refer to your product manual for the location of the learn button.
Note: Your product may look differed than the products illustrated in this manual
Only for use with Security+ 2.0™ garage door openers and universal receivers that have a yellow “learn” button.
Instructions are Described and Illustrated Below
-
Press and release the “learn” button on the motor unit. The learn indicator light will glow steadily for 30 seconds.
-
Within 30 seconds, press and hold any button on the hand-held remote.
-
Release the button when the motor unit I light blinks. It has learned the code. If light bulbs are not installed, two clicks will be heard.
Erase All Codes From Motor Unit Memory
To deactivate any unwanted remote, first erase all codes:
Press and hold the “learn” button on motor unit until the learn indicator light goes out (approximately 6 seconds). All previous codes are now erased. Reprogram each remote or keyless entry you wish to use
WARNING
To prevent possible SERIOUS INJURY or DEATH from a moving
gate or garage door:
- ALWAYS keep remote controls out of reach of childran. NEVER permit chiidren to operate, or play with remote control tranemutters.
- Activate gate or door ONLY when it can be seen clearly. is properly adjusted, and there are no obstructions to door travel.
- ALWAYS keep gate or garage door in sight until completely closed. NEVER permit anyone to cross path of moving gate or door.
The Remote Control Battery
WARNING
To prevent possible SERIOUS INJURY or DEATH:
- NEVER allow small chddran near battery.
- If battery is swallowed, immediately notify doctor.
The 3V 2032 battery should produce power for up to S years. To replace,
please loose 3 screws by screwdriver as shown. insert battery postive side up
(+).
Dispose of old battery property.
Replacement Part
- 3V 2032 battery
FCC Statement
FCC Caution：
This device complies with part 15 of the FCC Rules. Operation is subject to
the
following two conditions: (1) This device may not cause harmful interference,
and (2) this device must accept any interference received, including
interference that may cause undesired operation.
Any Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.
Note: This equipment has been tested and found to comply with the limits
for a Class B digital device, pursuant to part 15 of the FCC Rules. These
limits are designed to provide reasonable protection against harmful
interference in a residential installation.
This equipment generates uses and can radiate radio frequency energy and, if
not installed and used in accordance with the instructions, may cause harmful
interference to radio communications. However, there is no guarantee that
interference will not occur in a particular installation. If this equipment
does cause harmful interference to radio or television reception, which can be
determined by turning the equipment off and on, the user is encouraged to try
to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
The device has been evaluated to meet general RF exposure requirement. The device can be used in portable exposure condition without restriction.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>