RIDGID PC116TS Tube Stand for Power Tubing Cutter Machine Instructions
- June 6, 2024
- RIDGID
Table of Contents
RIDGID PC116TS Tube Stand for Power Tubing Cutter Machine
PC116TS Tube Stand Instructions
SAVE THESE INSTRUCTIONS!
- Position the PC116TS Tube Stand on a clear, level, stable location. This will reduce the risk of tipping.
- Properly support tubing. Failure to properly support tubing can cause stand tipping, falling tubes and serious injury.
- Use the PC116TS Tube Stand only with PC116/PTC-400 Power Tubing Cutter.
If you have any question concerning this RIDGID® product:
- Contact your local RIDGID distributor.
- Visit RIDGID.com to find your local RIDGID contact point.
- Contact Ridge Tool Technical Service Department at rtctechservices@ emerson.com, or in the U.S. and Canada call 800-519-3456.
Description
RIDGID® PC116TS Tube Stand is for use with PC116/PTC-400 Power Tubing Cutter to support tubing.
Specifications
-
Tube Size
1/2″– 4.5″ (12-120 mm) -
Weight Capacity
110 lbs. (50 kg) -
Height Adjustment
1″ (25 mm)
Figure 1 – PC116TS Tube Stand
Inspection/Maintenance
Clean the PC116TS Stand to aid inspection and improve control. Inspect
before each use for proper assembly, wear, damage, modification or other
issues that could affect safe use.
If any problems are found, do not use until corrected. Lubricate all moving
parts/joints as needed with light lubricating oil. Wipe up excess oil.
Set-Up and Operation
-
Make sure all equipment is inspected and set up per its instructions.
-
Locate a clear, level, stable location for the stand, other equipment and the operator.
-
To adjust ball rollers for tube size:
a. Depress button.
b. Move ball head to proper tube size position (see Figure 1).
c. Release button – confirm securely located. -
To adjust stand height, turn collar to raise or lower stand head. Stand is designed to be placed on the same flat surface as the PC116/PTC-400 Cutter. If needed, suitable spacers (such as a piece of wood) can be used to raise stand.
-
Place stands in line with PC116/PTC-400 rollers to properly support the tubing. Generally, tubing should be supported in at least two places. The number and placement of stands depend on the specific circumstances, including tubing size, length and weight.
-
Carefully place the tubing on the stands. Make sure that the tubing is properly centered on the stands to reduce the risk of tipping. Do not drop the tubing onto the stands. Do not exceed the stand ratings. Make sure tubing is stable and secure. Always stay clear of supported loads.
©2020, 2021 Ridge Tool Company. All rights reserved. RIDGID and the Emerson logo are registered trademarks of Emerson Electric Co. or its subsidiaries in the US and other countries. All other trademarks belong to their respective holders.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>