Super Lighting LED BC-204-DMX512 ArtNet-DMX Controller User Manual

Super Lighting LED BC-204-DMX512 ArtNet-DMX Controller

Brief Introduction

This Ethernet-DMX controller is dedicated to converting the Ethernet signal into DMX signal, output DMX512 signal, built-in test mode, SD record/play function, timer, etc.

Specification

Basic features

1. With LCD screen, easy to operate.
2. Support Ethernet DMX protocol ArtNet.
3. Support online firmware upgrade.
4.  Built-in test mode, SD record/play function.
5.  Support 8 timing play, 16 recording effects.
6.  Support maximum capacity Micro SD8G memory card (equipped). 7、 Use a DMX output with indicator,easy to operate.

Safety warning

1. Please don’t install this controller in lightening, intense magnetic and high-voltage fields.
2. To reduce the risk of component damage and fire caused by short circuit, make sure correct connection.
3. Always be sure to mount this unit in an area that will allow proper ventilation to ensure a fitting temperatu0re.
4. Check if the voltage and power adapter suit the controller.
5. Don’t connect cables with power on, make sure a correct connection and no short circuit checked with instrument before power on.
6. Please don’t repair without permission. Please contact supplier if problems occur.

The manual is only suitable for this model; any update is subject to change without prior notice.

Dimension

Operating instructions

1. Instruction of the interface and ports:

2. Key Description

3. Operating and setting instructions
   Instruction of interface
   
   Menu function
   Press M key to enter the Settings menu, Press the key move the cursor to the target position,tap the  key to enter the corresponding setting page.The following table shows a brief introduction to the Settings menu
   

4. Parameter Setting

DMX output setting

WEB setting, Firmware upgrading online
In addition to set parameters by keys, you can also set it through the Web browser of computer. The parameter settings between the two are the same; Open the web browser of the computer, which is in the same LAN with the controller, input the IP address (such as the default IP: 192.168.0.50), and press “Enter” to browse the controller’s built-in website, as shown below:

Parameter Settings

Test Mode Configuration

Firmware Update

If you need a firmware update，please contact the manufacturer to upgrade the firmware provided by the manufacturer

Load default

Press the button at the same time,and power up the controller, and then release the button when the recovery interface appears

Conjunction Diagram

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>