Super Lighting LED T21-1 Wall Mounted Touch Panel Instruction Manual
- June 5, 2024
- Super Lighting LED
Table of Contents
Super Lighting LED T21-1 Wall Mounted Touch Panel
Features
- Touch panel 4 zone 1-4 color RF remote
- Each zone can remote control multiple Skydance’s 2.4G LED controllers
- Ultra sensitive high strength glass touch panel with touch color wheel in the middle.
- Smooth and accurate color adjustment by touching the color slide.
- Touch keys with chord tones and LED indicator.
- Free installation, no wiring, removable
- AAA x 2 battery powered
- White & Black glass panel available
Technical Parameters
Input and Output
Output signol| RF12.4GHz)
Working voltage| 3VDCIAMx 21
Working current
| < 5mA(W ithou t tune)
< 20m Alwith tune)
Sta nd by current| < 20 1-1A
Stand by time| I yern
Remote distance| 30m (Barrier-free srxice)
Safety and EMC
EMC standard (EMC)
| ETSI EN 3(tl 489-1 V2.2.3
ETSI EN 3Ctl 4 89 -17 V3 .2.4
Safety standard(LVDI| EN 62368·l :2(t2(1+A1 1 : 21:12(1
Radio Eq uipmen11RED)| ETSI EN 3((1 328 V2.2.2
Certification| CE,EMC,LVD,RED
Warranty
Warranty 5 years
Environment
- Operation temperature Ta: -30°C ~ +55°C
- Case temperature (Max.) Tc:+65°C
- IP rating IP20
Mechanical Structures and Installations
To fix the panel, two options are offered for selection:
- Option l: fix it on the wall with two screws
- Option 2: adhere it to the wall with plaster
Match Remote Control (two match ways)
End user con choose the suitable match/delete ways. Two options are offered for selection·
Use the controller’s Match key
Match:
Short press match key, immediately press zone key of the touch panel.
The LED indicator fast flash a few times means match is successful
Delete:
Press and hold match key for 5s to delete all match. The LED indicator fast
flash a few times means all matched remotes were deleted
Use Power Restart
Match:
Switch off the power of the receiver, then switch on power, repeat again.
Immediately short press zone key 3 times on the touch fXlnel The light blinks
3 times means match is successful.
Delete:
Switch off the power of the receiver, then switch on power, repeat again
Immediately short press zone key 5 times on the touch panel. The light blinks
5 times means all matched remotes were deleted
Key function
Note: After touch power key to turn off light, long press power key for 5 seconds will turn on or turn off tone
Safety information
- Read all instructions carefully before you begin this installation
- When installing battery, pay attention lo the battery positive and negative polarity. A long time without the remote control, remove the battery When remote distance becomes smaller and insensitive, replace the battery .
- If no response from the receiver, please re-match the remote.
- Gently handle remote, beware of falling
- For indoor and dry location use only.