qtx HZ-1500LED LED Haze Machine 1500W User Manual

qtx HZ-1500LED LED Haze Machine 1500W

Caution: Please read this manual carefully before operating
Damage caused by misuse is not covered by the warranty

A high-efficiency 1500W haze machine capable of producing 20,000 cu.ft per minute of haze to rapidly fill larger venues. The haze effect can then be highlighted with an array of colours from the 9 bright LED’s housed in the front of the unit. The haze and light effects are easily controlled using either the included keyfob-style RF wireless remote or by 6-channel DMX connection. The 2.3 litre fluid bottle can be removed for easy refilling and there is a slot window to indicate the current fluid level.

• 1500W haze vaporizer with around 20,000 cu. ft/min output
• Nine powerful 3W LEDs add a bright colorful light show to the haze effect
• 433Mhz keyfob-style RF wireless remote
• 6-Channel DMX connections
• Removable 2.3 litre fluid tank
• High-grade haze fluid should be used with this machine (we recommend 160.591UK)

In the box

Please check the contents to ensure that the product has been received in good condition.

• HZ-1500LED Haze Machine
• RF Remote Control & transmitter
• UK/EU Mains Leads
• Mounting bracket & screws
• User guide

If you find any accessory is missing or the machine has arrived with damage, please contact your local dealer at once. Do not try to fix this item yourself or you will invalidate the warranty. Please keep the original packaging and invoice for any possible replacement or return demands.

Warnings:

1. To prevent risk of fire or electric shock, do not expose electrical parts to rain or moisture.
2. If liquids are spilled on areas other than inside the fluid tank, disconnect the mains, allow the unit to dry out and have it checked by qualified personnel before use.
3. Avoid any impact, dropping or extreme pressure to the housing.
4. No user-serviceable parts inside – do not open the case.
5. Allow the unit to acclimatize to room temperature before operating.
6. The HZ-1500LED has a built-in fluid container and should be operated in an upright position. Ensure that the unit is positioned on a stable, non-slip surface.

Safety and Cleaning:

1. Check for correct mains voltage and condition of IEC lead before connecting to mains.
2. This unit must be earthed.
3. This unit uses a heating element – be aware that parts of the housing may be hot during use!
4. Use a soft dry or slightly damp cloth to clean the casing.
5. Do not use strong solvents for cleaning the housing.
6. Clean the haze mechanism periodically by operating with distilled water.
7. It is also recommended to use fog machine cleaning fluid (160.670UK) periodically.

Recommended Fluids:
For the HZ-1500LED haze machine, we strongly recommend the following fluid which has been specifically formulated to perform best with any heater-based haze machines.

Rear Panel

Setting Up:

1. Unpack the HZ-1500LED unit.
2. Unscrew the top cap of the tank and remove to fill with haze fluid.
3. Replace the bottle and screw the cap securely, making sure that the pipe is fed down to the bottom of the bottle to ensure a consistent flow of fluid.
4. Connect the RF remote transmitter to the socket marked “Wireless” on the rear panel.
5. If DMX is to be used for control, connect the DMX signal from the controller to the DMX IN XLR connector. Any further DMX controlled units may be connected via theDMX OUT XLR connector.
6. Connect the IEC mains plug and power the unit on.
7. The unit will begin the warming up process which normally takes around 3-5 minutes.

Operation:
Use the control buttons on the rear panel of the unit to operate the unit’s modes and functions quickly and efficiently as below:

The LCD panel on the rear of the unit will display the following outputs:

The small RF remote control supplied can also be used when wireless control of the unit is needed. Ensure the wireless RF controller is connected to the unit, to use the remote for the following functions:

• R: Red LED control
• G: Green LED control
• B: Blue LED control
• FOG: Haze effect on demand

If the LCD panel display is set to DMX mode (d001-d512), the unit will operate by DMX control as follows:

Specifications

Troubleshooting

No power to main unit or wired controller| Check mains voltage is correct and socket is switched on
---|---
Check IEC lead is OK and connected properly
Check mains fuse in IEC connector and fuse in plug top
If fuse blowing repeatedly, refer to qualified service personnel
Power to unit but no haze output in manual or continuous mode| Check fluid level in tank
If fluid is OK and pump working, the lines may be blocked
Check that output is not set to zero on the control panel
Check that output is not switched off on the keyfob remote
If blocked, clean with fog machine cleaner & distilled water
Check that if DMX mode is selected, the DMX channel is correct
In DMX mode, check that haze output is not set to zero

This product is classed as Electrical or Electronic equipment and should not be disposed with other household or commercial waste at the end of its useful life. The goods must be disposed of according to your local council guidelines Errors and omissions excepted.

Copyright© 2022 AVSL Group Ltd, Unit 2 Bridgewater Park, AVSL (Europe) Ltd, Unit 3D North Point House, Taylor Road, Trafford Park, Manchester. M41 7JQ. North Point Bus. Park, New Mallow Road, Cork, Ireland

www.avsl.com

References

• AVSL
• AVSL

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>