JEGS 80519 Digital Caliper 6 in. 150 mm Length Installation Guide
- June 6, 2024
- JEGS
Table of Contents
Installation Guide for 80519
Digital Caliper
6 in. (150 mm) Length
1-800-345-4545
Features
| 1 | External Measuring Jaws | 8 | Output Connector |
|---|---|---|---|
| 2 | Internal Measuring Jaws | 9 | LCD Display |
| 3 | Depth Blade | 10 | Slider Clamp Screw |
| 4 | Step Measuring Faces | 11 | Thumb Roller |
| 5 | Beam | 12 | ON/OFF Switch |
| 6 | SAE & Metric Scale | 13 | Zero Switch |
| 7 | Battery Compartment | 14 | SAE & Metric Conversion Switch |
Read Before Installation
Thank you for your purchase of this JEGS 6 in. digital caliper.
Before using, please be sure to verify that the caliper is fully functional.
Reference the features on the previous page. If any components are damaged or
non-functional please contact customer service at: 1.800.345.4545.
If you are having issues, or have questions regarding the use of this digital
caliper, please contact our technical support department at: 1.800.345.4545.
Return Information: Before modifying any of the parts in this universal
digital dash panel, please trial-fit all components. Once this kit has been
modified, or wires cut it will not be accepted for return.
Technical Specifications
| Measuring Range: | 0-6 in. (0-150 mm) |
|---|---|
| Resolution: | 0.0005 in. (0.01 mm) |
| Accuracy: | ±0.001 in. (±0.02 mm) |
| Repeatability: | 0.0005 in. (0.01 mm) |
| Max Measuring Speed: | 60 in./sec (1.5 m./sec) |
| Measuring System: | Linear Capacitive |
Measuring System
Display:| LCD
Power:| (1) Alkaline Lithium Button Cell Battery
(1.5V, Type LR44)
Working Temperature:| 41°-140° F (5°-40° C)
Note:| Accuracy affected in environments with relative humidity in
excess of 80%
Troubleshooting
| Display Flashes: | Low battery | Replace battery |
|---|
Display Doesnt Change
when Slider is Moved:| System locked| Remove and replace
battery to reset (30 sec.)
Accuracy Less than
±0.001 mm:| Dirt in sensor| Remove slider cover
and blow clean
No Display on LCD:| Improper battery
position/Low battery| Check battery position/
Replace battery
Instructions
Outside Measurement
Step Measurement
Inside Measurement
Depth Measurement
Battery Replacement
A flashing display indicates a low battery.
To replace the battery:
- Remove the battery cover by sliding it in the direction of the arrow
- Pop-out the battery
- Install new battery with the (-) negative terminal facing down
- Replace cover and turn caliper on
Maintenance
- Keep the caliper clean and dry. Liquid can damage the slider.
- Use a clean, dry cloth to clean all surfaces. Do not use solvents or solvent-based cleaners
- To save power, turn off the unit when not in use
- Avoid contact with electricity or electronic devices
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>