iHome iBTW22 Timebase Wireless Charging Plus Speaker Instructions
- June 6, 2024
- iHome
Table of Contents
iBTW22 Timebase Wireless Charging Plus Speaker
Instructions
Model: iBTW22
TIMEBASE
Wireless Charging + Speaker
WIRELESS CHARGING PAD
POWER
– Press to turn ON/OFF
SET +
– Press to decrease settings
SET –
– Press to increase settings
SNOOZE/DIMMER zzz
– Press to snooze an alarm
– Press to adjust display brightness
AUTO-DIMMING SENSOR
SPEAKERPHONE
– Press to answer a call
– Press & hold to end/reject a call
– When connected to a BT device, press to make voice commands
PLAY/PAUSE
-Press to play/pause audio
ALARM
– Press to Preview
– Press Again to Arm/Disarm
– Press & Hold to Set Alarm (adjust with +/- and press alarm to confirm)
REAR PANEL
BOTTOM PANEL
DISPLAY ICONS
WIRELESS CHARGING
Supports:
- Qi-compatible phones (also works with plastic cases up to 3mm thick*)
- Apple Air Pods?
Place Qi-compatible device facing forward on the charging rest. Charging status will be indicated on the LED located under the iHome badge:
- Rapid blinking LED: Device is not charging (reposition device)
- Slow blinking LED: The device is charging
- Solid LED: The device is fully charged
Note: Qi status LED may continue to blink slowly (indicating charging)
for iOS devices that are fully charged.
CAUTION: Not all cases are wireless charging compatible. Remove the
phone’s metal protective case before charging. Do not place magnetic or metal
objects on the charger during charging.
- Some larger size phone cases may not be able to charge. Please remove the case to charge the phone properly.) For questions, warranty, and additional safety information, please scan the QR code or visit: www.ihome.com/help/ibtw22
WARNING
-
Do not ingest the battery, Chemical Burn Hazard. This product contains a coin/button cell battery. If the coin/button cell battery is swallowed, it can cause severe internal burns in just 2 hours and can lead to death.
-
Keep new and used batteries away from children. If the battery compartment does not close securely, stop using the product and keep it away from children. If you think batteries might have been swallowed or placed inside any part of the body, seek immediate medical attention.
-
The mains plug of the power adaptor is used as the disconnect device, it shall remain readily operable.
-
CAUTION – RISK OF EXPLOSION IF BATTERY IS REPLACED BY AN INCORRECT TYPE. DISPOSE OF USED BATTERIES ACCORDING TO THE
INSTRUCTIONS. -
The socket outlet shall be installed near the equipment and shall be easily accessible.
IMPORTANT SAFETY INSTRUCTIONS
Please heed all warnings, read and follow all instructions and keep these
instructions handy for future reference.
-
Do not use this product near water.
-
Unplug the unit and clean only with a damp cloth. Stronger cleaning agents, such as Benzene, thinner, or similar materials can damage the surface of the unit.
-
Do not block any ventilation openings. Install in accordance with the manufacturer’s instructions.
-
Heat This product should be situated away from heat sources such as radiators, heat registers, stoves, or other appliances (including amplifiers) that produce heat.
-
Only use attachments/accessories specified by the manufacturer.
-
Unplug this product during lightning storms or when unused for long periods of time.
-
Damage Requiring Service This product should be serviced by qualified service personnel when:
– Plug has been damaged.
– Objects have fallen into or liquid has been spilled into the enclosure.
– The unit has been exposed to rain. The unit has been dropped or the enclosure damaged.
– The unit exhibits a marked change in performance or does not operate normally. -
No naked flame sources, such as lighted candles, should be placed on this product.
-
Attention should be drawn to the environmental aspects of battery disposal. Many electronics retailers now recycle batteries and other electronic components at no charge. To find a drop-off location near you, visit www.call2recycle.com
-
This product is suitable for use in tropical and/or moderate climates.
WARNING:
– To reduce the risk of fire or electric shock, do not expose this product to
rain or moisture.
– Do not dispose of batteries in the household trash or fire.
FCC Information
This equipment complies with FCC RF radiation exposure limits set forth for an uncontrolled environment. This device complies with Part 15 of the FCC Rules, the operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.
-
Warning: Changes or modifications to this unit not expressly approved by the party responsible for compliance could void the user’s
authority to operate the equipment. -
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
This equipment should be installed and operated with a minimum distance of
20cm between the radiator & your body.
ISED Information
This equipment complies with IC RSS-102 radiation exposure limits set forth
for an uncontrolled environment. This device contains license-exempt
transmitter(s)/receiver(s) that comply with Innovation, Science, and Economic
Development Canada’s license-exempt RSS(s).
Operation is subject to the following two conditions:
(1) This device may not cause interference.
(2) This device must accept any interference, including interference that may
cause undesired operation of the device. The device complies with the ISED RF
exposure requirement, users can obtain Canadian information on RF exposure and
compliance. This equipment should be installed and operated with a minimum
distance of 20 cm between the radiator and your body. Any changes or
modifications not expressly approved by the party responsible for compliance
could void the user’s authority to operate the equipment.
CAN ICES-3 (B) / NMB-3(B), CAN RSS-216 / CNR-216
iBTW22IS-042121-A
© 2021 SDI Technologies, Inc. All rights reserved
iBTW22
Instruction Sheet
Color: Black text on white paper (1C + 1C)
Size: 102 W x 150 Hmm
Material: 85gsm wood free paper
April 21, 2021
Printed in China