XIGMATEK FROZR-O-240 AIO Liquid Cooling System User Manual
- June 6, 2024
- XIGMATEK
Table of Contents
FROZR-O-240 AIO Liquid Cooling System
USER MANUAL
FROZR-o 240 A10
XIGMATEK
http://www.xigmatek.com
E-mail sales@Jx1gmatek com
2021 Cl XIGMATEK Co, Ltd All rights reserved
All trademarks are the property of their respective owners.
- Keep and store the product away from the reach of children.
- Check the component list and condition of the product before installation. If there is any problem, contact the shop where you purchased to get a replacement or refund.
- Xigmatek Co., Ltd. is not responsible for any damages due to external causes, including but not limited to, improper use, problems with electrical power, accident, neglect, alteration, repair, improper installation, and improper testing.
- CPU and motherboard are subject to damage if the product is incorrectly installed.
FROZR-O 240 ACCESSORIES
Intel LGA 115x / 1200 / 1366
-
Insert screw bolts to Intel 11Sx or 1336 backplate mounting holes.2.lnstall screw bolt washers to lock the screw bolts & backplate.
-
Make sure the screw bolt is lock in on the backplate.
-
Install the backplate to motherboard
Remove copper cold plate protective film.
Install the Intel pump head mounting brackets.
-
Clean the CPU surface. 2.Apply and spread the thermal paste to CPU evenly using included spatula. 3.Place the stand-off to backplate screw bolt.
-
Align the Intel pump head mounting brackets to backplate screw bolts, then place the pump head on the CPU carefully.
-
Using spring screw nuts to complete the pump head and motherboard installation.
Intel LGA 2011 / 2066
- Remove copper cold plate protective film.
2. Install the Intel pump head mounting brackets.
3. 1. Clean the CPU surface.
2. Apply and spread the thermal paste to CPU evenly using included spatula.
4. 1. Align the Intel 2011/2066 pump head mounting brackets to backplate screw bolts, then place the pump head on the CPU carefully.
2. Uslng spring screw to complete the pump head and motherboard installation.
Smart OLD Display
AMD AM3 / AM4
Cable & Connector Installation
ARGB Remote Controller
CAUTION
To Sync with the ARGB motherboard, press M/B SYNC button after connecting the
fans and ARGB cable to motherboard ARGB header.
Galaxy II Fan Control Box
- Fan 1-8: 6Pin Port
- Power: 4Pin Molex Power Connector (To PSU)
- LED SPEED
- MODE
- FAN SPEED
- LED: ARGB Port (Connect Other ARGB Accessories)
- DATA: ARGB Port (Connect to ARGB Motherboard)
- Reset SW: Connect to PC Case Reset Button To Change Color Mode)
ARGB Control Box Power Consumption
Total 40W maximum
12V: Total 36 W maximum
Caution: Please do not over power the controller box, it is dangerous and might cause damage!
CAUTION
- Please check your PSU SV & 12V power output specification, make sure PSU single 4pin molex connector can support sufficient power output to avoid PSU cable over heat and meltdown.
- Please use at least 450W PSU and 18AWG thickness 4Pin Molex cable if connect more than 6 fans.
- It will NOT work with 4 pin RGB or 12V RGB fans or light stripes.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>