XIGMATEK ANUBIS PRO Mesh Argb Super Tower Case Installation Guide

XIGMATEK ANUBIS PRO Mesh Argb Super Tower Case

Accessory Pack Contents

Case Features

Removal of Panels

• Unscrew side-panel thumb-screws.
• Slide side panels back to release.

• Find the front panel cut-out.
• Firmly stabilize the chassis with one hand.
• Apply a gradual pulling force with your other hand (using the cut-out).
  Note: Be wary of wires attached to front panel.

Motherboard Installation

• Find the correct stand-off locations by aligning with your motherboard and fasten needed stand-offs accordingly.
• Insert your motherboard 1/0 back-plate into the cut-out.
• Place your motherboard into the chassis with the ports inserted into the 1/0 back-plate.
• Anchor the motherboard with the motherboard screws provided.

Add-On Card Installation

Add-On Card Installation

• Apply pressure and bend the add-on card cover until it comes free.
• Slide the PCI/PCI-E card into position and secure with provided ‘Add-On Card Screw’.

Power Supply Installation

• Place PSU on the bottom of the case.
• Align holes and secure with screws.

3.5″ HDD Installation

• Use screws to lock in hard drive first.
• Place your 3.5″ HDD in.
• On the other side, use hands to screw the screws in to put hard drive in place.

2.5″ SSD Installation

Insert 2.5-inch hard drive, insert screws from the side.

Top / Front I MB Panel Fan lnsatallation

Fan Installation
Align and secure your 120mm fan with screws.

Rear Panel Fan Installation

Fan Installation
Align and secure your 120mm fan with screws.

Liquid Cooling Installation

Secure the fans on the radiator and fasten the radiator inside of the casing by screwing it from the outside.

www.xigmatek.com
E-mail: sales@xigmatek.com
XIGMATEK is Registered Trademark of Xigmatek Co., LTD.
Copyright © 2023-2027 All Rights Reserved

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>