airbi D6810208 SPACE WiFi Air Purifier Instruction Manual
- June 6, 2024
- airbi
Table of Contents
Air purifier
Airbi SPACE WiFi
Instruction manual
(version 1.0)
Please read the instruction manual carefully before using this appliance!
Important safety instructions
Please read through the operating instructions carefully before you use the appliance for the first time and keep them safely for later reference. If necessary pass them on to the next owner.
- The appliance is only to be used in the home for the purposes described in these instructions. Unauthorized use and technical modifications to the appliance can lead to danger to life and health.
- This appliance can be used by children aged 10 years and above and persons with reduced physical, sensory or mental capabilities or lack of experience and knowledge if they have been given supervision or instruction concerning use of the appliance in a safe way and understand the hazards involved. Children shall not play with the appliance. Cleaning and user maintenance shall not be made by children without supervision.
- After unpacking, make sure that the appliance wasn’t damaged during transport. If you find any damage, contact your dealer as soon as possible. We recommend you keep the packaging for possible future use.
- Before first use check that the device parameters (electric voltage, etc.) correspond to local conditions.
- Use appliance in an environment of 10°C to 30°C. Do not use outdoors.
- Please put appliances more than 1 meter away from TV or radio. It is recommended to put the appliance on flat ground in the room.
- Do not place the appliance near a heat source. Do not subject the power cord to direct heat (such as a heated hotplate, open flames, hot iron sole plates, or heaters for example). Protect power cords from oil.
- Always put the appliance on a hard, flat horizontal surface. There should be a gap of at least 20 cm at both sides and back of the product, while 30 cm from the top surface.
- Do not place anything on the appliance and do not block the air inlet and outlet.
- Before using the appliance, check if the AC adapter or power cord is not damaged. Do not use it if the cord is damaged.
- If the power cord is damaged, it must be replaced by the manufacturer or a repair shop authorized by the manufacturer or by similarly qualified persons in order to avoid a hazard
- Switch off and unplug the unit before any manipulation such as cleaning of filters maintenance.
- Do not lift or move the appliance when it is working.
- Do not touch the power cord with wet hands, may cause electric shock.
- Do not insert fingers or metal objects into the air outlet gap, may cause electric shock.
- Do not let water, flammable detergent or other liquid get into the product, may cause the electric shock of fire.
- This product is not supposed to be used as a daily ventilator, dust cleaner, or cooker hood.
- Do not place appliances in too humid or too hot places.
- Do not use the appliance in an aromatherapy scent insecticide environment.
- Store the appliance in a dry place inaccessible to children (pack the appliance).
- The manufacturer is not responsible for any damage due to improper use of the appliance.
Packing list
- appliance
- prefilters (2 pcs)
- filters (2 pcs)
- user manual
Purifier‘s scheme
- Base
- Kombi filter (HEPA + active carbon)
- Prefilter
- Filter’s cover
Before first use
-
Open filter’s covers and take out prefilters and combi filters (HEPA + active carbon)
-
Remove all packaging material
-
Install filters back to their position and put back both covers.
Control overview and operation instructions
- Switch on/off button
- Mode button
- Fan speed button
- Maintenance indicator button
- Timer button
- Child lock button
After you connect the power cord to the electric socket, you hear sound notice and see all segments on display for while. The appliance is now in standby mode. Air quality indicator lights are on in red color.
Power button
Press on/off button once and the appliance switch on in automatic mode. Press once again and the appliance switches off (standby mode). Please note that the appliance has a built-in security function – it will switch off if the filter’s cover is open.
Mode button
By mode, the button user can change the mode of operation – automatic, smoke, or night.
- Automatic – speed of fan depends on air quality in automatic mode. Air quality is monitored by a built-in PM2.5 dust sensor. On display symbol.
- Smoke – fan is set to maximum speed and on display is a symbol
- Noční – fan is set to minimum speed and on display is a symbol after while display switches off. If some button is pressed, the display will light on for while and then switch off again.
Speed button
By speed, the button user can change the speed of the fan – low, middle, high, and on display is symbol according to the selected speed.
Child lock button
With this button, the user can activate the child lock function. All buttons will be disabled when the child lock is active. Press this button for 5 seconds to deactivate this function.
Timer button
By pressing the timer button repeatedly the user can set a timer for 1-12
hours.
Preset time is indicated by an LED on top panel that is light on. If is timer
function active, the user can check the remaining time (in minutes) by
pressing the timer button in normal mode. If the timer’s LED doesn’t light on
it means the timer is not active.
Filter button
The appliance has a maintenance indicator button that can notify users doing filter maintenance.
- The filter button starts to blink after 300 hours of work. That means the user should do filter maintenance – more in paragraph Product care and maintenace. After it is done, the user must reset the indicator by pressing the filter button for 5 seconds.
- The filter button starts to light on red after 4500 hours of work. In this case, is necessary to change kombi filters in the appliance. After it is done, use must reset the indicator by pressing filter button for 5 seconds.
NOTE: The current working time since the last reset can be shown on the display by briefly pressing the filter button once. The first number that appears on the display means thousands, the second number that appears after a while means hundreds, tens, and units of hours. E.g. if the first number is 1 and the next number is 358, it means that the device has been in operation for 1358 hours since the last reset of the indicator.
Air quality indication
Air quality indicator (7) informs user about ambient air quality.
Blue color means excellent air conditions, green color indicates good air,
orange color indicates worse air conditions and red color means that air
quality is bad.
Connection to WiFi – control by app
https://www.airbi.cz/space-wifi
You can use the application on your smartphone or tablet (iOS, Android) to control the device. Before the device can be controlled via the application, it is necessary to configure the device and allow it to connect to a WiFi network. Instructions for the application and setup of the device can be found at www.airbi.cz/space-wifi
Product care and maintenace
Warning : Ensure to disconnect the power before cleaning and maintenance.
Pre-filter (every 15 days)
- Please use the vacuum cleaner to clean the dust on the surface of the screen or wash with water, dry thoroughly.
HEPA / carbon filter
(every two months)
- Use the vacuum cleaner to clean the dust on the surface of the screen.
- Place the filter into the ventilated place.
- Don’t expose to the strong sunshine.
- Do not use water to clean the filter.
Particle sensor
(every two months)
- Remove sensor’s cover.
- Use a dry cotton swab to clean the sensor.
- Regularly clean the sensor from dust.
- Use the flashlight if you do not see the sensor
Air outlet and ionizer
(every two months)
- On the top grid find a symbol.
- Lift the side with this symbol and carefully remove the grid.
- Use the vacuum cleaner and collect dust from the top of the unit.
- The ionizer is located at the air outlet at the top of the instrument (side with the symbol ). If you do not see the ionizer, use a flashlight.
- Use a brush pen to gently clean the ionizer from any dust that has been collected.
Note
- Please unplug the power if the appliance is not in use for a long time.
- According to the use of places and methods (e.g. family with many smokers or the place with serious pollution), the filter life will be shortened. Please replace the filter in time.
- To clean the device, do not use any aggressive concentrated detergents.
- Air purifier is working silently, but not without any noise. The purifier‘s noise of less than 66 dB is not a fault.
Filtration system
- Pre-filter: Dust capturing filter at the front. Is able to filter pollutants like large dust particles, hairs, pollen, suspended particles, etc. Is washable and reusable
- Activated Carbon Filter – Absorbs various smells, such as formaldehyde. This colorless gas with a strong odor is often considered the most dangerous harmful substance inside flats because it is highly irritating for the upper airways and eyes.
- True HEPA filter: Adsorbs particulate down to 0.0001mm like pollen, drifting dust, and germs with purification efficiency of more than 99.9%. Prevention of the spread of airborne bacterial and viral organisms.
- Anion generator (ionizer): Double core anion generator releases a large number of anions and makes the oxygen negatively charged. Anions not only remove dust, kill bacteria and purify air efficiently, they also facilitate the synthesis in human bodies and the storage of vitamins. The ionizer can be switched on or off by simultaneously holding down the mode button [2] and the filter button [4] for 3 seconds. One beep indicates that the ionizer is on, two beeps indicate that this function is off.
Replacing the filters
The device is equipped with a filter maintenace indicator. You can find more
information in paragraph Control overview and operation instructions.
Troubleshooting
Trouble
|
Solution
---|---
Can not turn on or button has no response| • Check the power cord if is
plugged in.
• Check the filter‘s covers and top grid if it is on its position.
• Check if appliance is not in Child-lock mode.
Air is dirty, but the indicator still show green color.| • Particle sensor is
dirty, you have to clean it.
Strange sound during operation.| • Negative ion generator has too much dust,
clean it.
Strange smell from appliance.| • filters are dirty, clean or replace filters.
Purifier work time is long, but air quality not improved.| • Check if you
removed filter bags.
• Check if you install filters in correct order.
Technical specification
Rated voltage
Power
WiFi frequency
Standard
Max. radio power
Noise
Ionizer
Air performance
Max. room dimension
Dimensions
Weight| 220-240 V, 50/60 Hz
85 W
2,4 GHz
IEEE 802.11 b/g/n
20 dBm
< 66 dB (A)
10 million/cm 3
800 m 3 /h
160 m 2
400 x 400 x 669 mm
14 kg
---|---
Disposal of the device (environment)
The European directive 2012 / 19 / CE on Waste Electrical and Electronic
Equipment (WEEE), requires that old household electrical appliances must not
be disposed of in the normal unsorted municipal waste stream. Old appliances
must be collected separately in order to optimize the recovery and recycling
of the materials they contain and reduce the impact on human health and the
environment. The crossed-out “wheeled bin” symbol on the product reminds you
of your obligation, that when you dispose of the appliance it must be
separately collected.
Consumers should contact their local authority or retailer for information
concerning the correct disposal of their old appliances.
This product is in compliance with the essential requirements and other
relevant provisions of EMC directive 2014/30/EU. The device was approved for
use in EU countries, therefore, bear the CE. All necessary documentation is
available at the importer’s address.
Changes in technical parameters, properties, printing errors in the
instruction manual reserved.
Importer Address:
Bibetus s.r.o.
Loosova 262/1
Brno 638 00
Czech republic
E-mail: info@bibetus.cz
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>