Fovaa P01Q Waterproof RGBW LED Strip Light User Manual
- June 6, 2024
- Fovaa
Table of Contents
Fovaa P01Q Waterproof RGBW LED Strip Light User Manual
Packing list
Specification
Product Features
Attention
- Please follow the instruction to connect properly, prevent damage to the Product.
- Do not disassemble or cut it casually, avoid effecting product used and maintenance.
- If a fault occurs please contact with us. Do not attempt to f x this by yourself.
- During installation, violent pulling and bending are prohibited.
- Do not cut off the cable wire between connector and adapter.
- Do not roll out the product on rough surfaces or over sharp corners. This will scratch the PVC and damage the f nish of the product.
- Do not secure the product with staples, nails, or alike that might damage the insulation or PVC material.
- Always make sure that the equipment is installed securely and ensure all safety anchors are installed.
Installation
-
.Choose a dry, clean and smooth surface.
-
Clean the dust with the cloth.
-
Warm the tape with a hair dryer when it’s below 10 C /50 F.
-
Strip off the protective f lm; (Notice: Do not peel off the tape under the f lm.)
-
Stick the strip light and press over it about 10-15s.
-
Reinforce via clips and screw provided. (4pcs/m)
Remote Controlling Guide
-
Download and install the Fovaa APP via mobile phone from app store.
-
Turn on Bluetooth via mobile phone, Enter Fovaa app and register.
-
Auto scan interface enable the Bluetooth, click start scanning and added the device.
-
Enter the Control interface, freely control the mode as you want.
NOTE: This equipment has been tested and found to comply with the limits for a
Class B digital device, pursuant to part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates uses and can radiate radio
frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful interference to
radio or television reception, which can be determined by turning the
equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
-Reorient or relocate the receiving antenna.
-Increase the separation between the equipment and receiver.
-Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
-Consult the dealer or an experienced radio/TV technician for help for compliance could void the user’s authority to operate the equipment.
This device complies with Part 15 of the FCC Rules. Operation is subject to
the following two conditions:
(1)this device may not cause harmful interference.
(2)this device must accept any interference received, including interference
that may cause undesired operation.
Read More About This Manual & Download PDF:
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>