Fovaa N16Q Boat RGBW LED Strip Light User Manual
- June 5, 2024
- Fovaa
Table of Contents
N16Q Boat RGBW LED Strip Light
User Manual
BOAT RGBW LED STRIP LIGHT
Packing list
Specification
Product Features
Attention
- Please follow the instruction to connect property, prevent damage to the Product.
- Do not disassemble or cut it casually, avoid effecting product used and maintenance.
- If a fault occurs please contact with us. Do not attempt to fix this by yourself,
- If the product installed underwater or swimming pool, please note that the depth does not exceed to 2 meters.
- During Installation, violent pulling and bending are prohibited.
- Do not roll out the product on rough surfaces or over sharp comers. This will scratch the PVC and damage the finish of the product
- Do not art off the cable wire between connector and adapter.
- Do not start the product with staples, nails, or alike that might damage the insulation or PVC material.
- Always make sure that the equipment is installed securely and ensure all safety anchors are installed
- This Is 12VDChput product. Do not connect directly with high voltage like 120VAC, or the action would damage LED strip light.
LED strip light must be installed by at least 2 people, who can support the product h various locations as shown. During Installation, care should be taken to ensure the bending radius of is not exceeded.
Installation
1. Mark the screw hole position on the boat.
2 Screw the plastic mounting cups ( 4pca/m) up on the boat.
3. Install LED strip light on the clips, plug the power on.
Remote Controlling Guide
1. Download and install the Fovaa APP via mobile phone from app store.
2. Tum on Bluetooth via mobile phone, Enter Fovaa app and register.
3. Auto scan interface enable the Bluetooth, dick start scanning and added the device.
4. Enter the Control Interface, freely control the mode as you want.
FCC Statement
FCC ID: 2AY4S-N16Q
NOTE: This equipment has been tested and found to comply with the limits for a
Class B digital device, pursuant to part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a
residential installation, This equipment generates uses and can radiate radio
frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a
particular
installation, If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and
on, the user is encouraged to try to correct the interference by one or more
of
the following measures:
- Reorient or relocate the receiving antenna,
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help
Changes or modifications not expressly approved by the party responsible for
compliance could void the user’s authority to operate the equipment.
This device complies with Part 15 of the FCC Rules. Operation is subject to the
following two conditions:
(1) this device may not cause harmful interference, and
(2) this device must accept any interference received, including interference
that
may cause undesired operation,
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>