Eis J02008-03-06 Remote Control User Manual
- June 6, 2024
- Eis
Table of Contents
Eis J02008-03-06 Remote Control
Product introduction
Remote control has good hand feeling, simple and convenient operation, and is comfortable. Suitable for Double Fun/Double Love/Little Secret series, etc.
Panel description
- “A” key: ON / OFF
- “B” key: Increase Intensity.
- “C” key: Decrease Intensity.
- “D” key: Switch modes.
Battery Installation
Open the battery compartment, install one piece 3V button battery, as shown in the figures:
Technical Specifications
- Remote control distance: ≥5M
- Power supply mode: CR2025 – 3V button battery
- Frequency: 433.920MHz
FCC Statement
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:
- This device may not cause harmful interference
- this device must accept any interference received, including interference that may cause undesired operation.
Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.
This device complies with Industry Canada licence-exempt RSS standard(s).
Operation is subject to the following two conditions:
- This device may not cause interference
- This device must accept any interference, including interference that may cause undesired operation of the device.