TIMESS X366 Wireless Car Charger User Manual

TIMESS X366 Wireless Car Charger

Instructions

Operation steps

1. Adjust the screw cap to the best active status
2. Must use Qualcomm quick charge adaptor for fast wireless charging.
3. Press the button of dip ID fix, then adjust the an~ and tighten the fixed nut
4. Place smartphone: The charger can sense your phone when approach,lhe clips will automatlcally grip your phone and wireless charge.
5. Take off smartphone
6. LED indicated light shows the working status:
7. Blue llght 1B on when charging
8. Red light flashes when sensing foreign bodies

Features

• Wireless charging for devices with Qi standard.
• Charging fast at lOW, 7.5w and ordinary at SW, compatible with Apple and Android devices.
• Wireless charging sensing: when the phone with wireless charge receiver approaches the charger, the two clips will automatically clip the phone and charge wirelessly.
• Foreign body detection sensing: when the phone without wireless receiver approaches the charger, the two clips will also automatically clip the phone, then use it for a phone holder
• The clips can extend and retract flexibly, so easily fix phone to charge or release to use .
• New upgrade mute design: Using the mute motor, the clips stretch and shrink with no noise
• 360 rotation: The handle supports 36o rotation, which enables you to find suitable directions to place your phone on or get your phone off .
• Over-current protection, over-heat protection and short-circuit protection.
• Certification: FCC,CE,ROHS.

Specification

• Material: ABS+ silica gel
• Wireless charging effective distance: 3-6mm {Max)
• Conversion efficiency:Normal charge~70%, Fast charge~75%
• Working frequency: 110-205kHz
• Color: Black
• Packing list :1 full-automatic wireless charger, l car outlet clip, 1 USB cable, 1 user manual

Warranty

This device Is free from defects In materlal and workmanship under normal use for twelve (12) months commencing upon the date of purchase. Proof of purchase is required for warranty service. The consumer should never attempt to open or disassemble the device, and doing so may cause damage that voids your warranty.

FCC Warning Statement

NOTE: This equipment has been tested and found to comply with the requirements for a Class B digital device under Part 15 of the Federal Communications Commission (FCC) rules. These requirements are intended to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.

WARNING: Changes or modifications to this equipment not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.
This device complies with Part 15 of the FCC rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. Privacy of communications may not be ensured when using this telephone.
To ensure safety of users, the FCC has established criteria for the amount of radio frequency energy that can be safely absorbed by a user or bystander according to the intended usage of the product. This product has been tested and found to comply with the FCC criteria. The handset may be safely held against the ear of the user. The telephone base shall be installed and used such that parts of the user’s body other than the hands are maintained at a distance of approximately 20 cm (8 inches) or more.
This Class B digital apparatus complies with Canadian requirement: CAN ICES-3 (B)/NMB-3(B).

Read User Manual Online (PDF format)

Download This Manual (PDF format)

Download this manual  >>