Mobile Technologies 15000256 Freedom Focus Merchandise Theft Deterrent System User Manual

Mobile Technologies 15000256 Freedom Focus Merchandise Theft Deterrent

System

COMPONENTES AND ACCESSORIES

ATTACH  BASEPLATE -VHB 

MOUNTING RISER TO FIXTURE-VHB

MERCHANDISING -SHELL 1

MERCHANDISING -SHELL 1

MERCHANDISING -SHELL 2

MERCHANDISING -SHELL 2

MERCHANDISING -SHELL 2

PUCK REMOVAL

CHARGE CABLE REMOVAL 

VHB POSITION REMOVAL

LENS SENSOR INSTALACIONES

CONNECTING POWER

RFID CARD PROGRAMMING

RIFD CARD OPERATION

USER CARD

DIMENSIONS- RISER- SHELL 1

DIMENSIONS- RISER- SHELL 2

DIMENSIONS – MOUNTING  ADAPTER

FCC AND ISED STATEMENT

FCCID:2AA2X-15000256
Model: FREEDOM FOCUS
FCC Statement
This device complies with Part 15 of the FCC Rules.
Caution: If any changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.
Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) This device must accept any interference received, including interference that may cause undesired operation.
The grantee is not responsible for any changes or modifications not expressly approved by the party responsible for compliance. Such modifications could void the user’s authority to operate the equipment.
This equipment can be installed and operated with a minimum distance 20 millimeters between the radiator and user’s body.
And this equipment has been evaluated to meet general RF exposure requirement at 20 millimeters distance.
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.

ISED Certification Number: 24439-15000256
Model: FREEDOM FOCUS
ISED Statement
This device complies with Innovation, Science and Economic Development Canada licence-exempt RSS standard(s). Operation is subject to the following two conditions: (1) this device may not cause interference, and (2) this device must accept any interference, including interference that may cause undesired operation of the device.
CAN ICES-3(8)/NMB-3(8)
Le present appareil est conforme aux CNR Innovation, Sciences et Developpement economique Canada applicables aux appareils radio exempts de licence. L’exploitation est autorisee aux deux conditions suivantes:
(1) ii ne doit pas produire de brouillage et (2) I’ utilisateur du dispositif doit etre pret a accepter tout brouillage radioelectrique rei;:u, meme si ce brouillage est susceptible de compromettre le fomctionnement du dispositif.
CAN ICES-3(8)/NMB-3(8)
The device meets the exemption from the routine evaluation limits in section 2.5 of RSS 102 and compliance with RSS-102 RF exposure, users can obtain Canadian information on RF exposure and compliance.
Le dispositif rencontre !’exemption des limites courantes d’evaluation dans la section 2.5 de RSS 102 et la conformite a !’exposition de RSS-102 rf, utilisateurs peut obtenir !’information canadienne sur !’exposition et la conformite de rf.
This transmitter must not be co-located or operating in conjunction with any other antenna or transmitter. This equipment should be installed and operated with a minimum distance of 20 millimeters between the radiator and your body.
Cet emetteur ne doit pas etre Co-place ou ne fonctionnant en meme temps qu’aucune autre antenne ou emetteur. Cet equipement devrait etre installe et actionne avec une distance minimum de 20 millimetres entre le radiateur et votre corps.

Technical Data

• Operating Temperature:      5 C to 40°c
• Operating Frequency:          2405 MHz to 2480 MHz
• Max Power:                        Less than 4 dBm at 2.4 GHz
• Operating Frequency:        125kHz
• Max Power:                        Less than 20 dBuA/m at 3m

Additional Safety Information

1. For indoor use only. The apparatus shall not be exposed to water.
2. No user-replaceable parts inside; refer servicing to the manufacturer or qualified service personnel.
3. Only use accessories specified by the manufacturer.
4. Do not expose to excessive heat sources.

Disposal: All electrical and electronic products including batteries should be disposed of separately from the municipal waste stream via designated collection facilities appointed by the government or the local authorities.

This product contains a rechargable battery. Proper storage, use, and disposal of the battery is important. Please refer to the guidelines below:

1. Properly dispose of the battery; Do not dispose of the battery into a furnace/oven or into a fire or mechanically crush or cut the battery, as this could cause the battery to explode.
2. Storing the battery in an environment at higher temperatures than stated above can result in explosion or leaking of flammable liquid or gas.
3. Subjecting a battery to very low air pressure or high altitudes can result in explosion or leaking of flammable liquid or gas.

www.MTIGS.com I T:800.426.6844

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>