STC-IP11 Static Power Bank User Guide

STC-IP11 Static Power Bank

Product Specification

Please check the components before use.

• Case: 1EA
• Battery: 1EA
• Quick start guide: 1EA

How to use the power bank

Smartphone case and power bank combination

Slide the phone into the case from the top down.
Move around slightly to make sure it fits properly

There is a built-in iron plate inside the case.
Be careful not to lose it.

Charging the power bank

Connect the Lightning cable to the power bank to charge.
It is recommended to use a MFI certified Lightning cable, and an adapter that supports 7.5W or higher power.

• Do not charge more than 24 hours.

* Up to 10W (5V/2A) can be charged using the fast charging adapter.

Smartphone wireless charging method

After placing the power bank on the back of the smartphone case and pressing the power button, the LEDs light up and wireless charging begins.

Do not charge the smartphone without the smartphone case.

Ensure there are no foreign metal objects (cards, magnets etc.) between the power bank and the smartphone.

Simultaneous charging of the power bank and the smartphone

Normal method
Simultaneous charging is possible by connecting the Lightning cable to the power bank after combining the smartphone with the power bank.

Other method
Simultaneous charging is possible by combining the smartphone while charging the power bank and pressing the power button of the power bank once.

( It is not necessary to press the power button if the smartphone is connected to the power bank within 15 seconds.)

LED indicator lights

Normal charging mode

You can check the remaining battery level using the LEDs on the front of the product.

Low battery indication (under 15%) – 1 LED blinks

Charging status
When charging, the LEDs blink as below:

Simultaneous charging mode

You can charge the power bank and the smartphone at the same time.

The LEDs only blink for the first 15 seconds of charging

Simultaneous charging
The LEDs blink sequentially from bottom to top, and then the LEDs flash according to the remaining battery level.

Product Specification

radio equipment
Battery rated capacity| Secondary Li-Polymer
3.7V === 5000mAh
USB input / Wireless output| 5.0V === 2.0A / 9.0V === 1.11A
Wireless charging frequency| 110.01khz ~ 146khz
(Output power)| (4.62 dBuA/m at 10m, 5W)
110.01khz ~ 133khz
(0.94 dBuA/m at 10m, 10W)
Weight / Size / Battery type| iPhone X/XS/11Pro
Case_ 53g/76x147x11 (mm)
Battery150g/72x108x17 (mm)
1INP10/56/66
iPhone XR/11
Case 55g/79x155x12 (mm)
Battery152g/76x111x17 (mm)
1INP10/56/66
iPhone 12/12Pro
Case 48g/76x151x11 (mm)
Battery_130g/76x110x12 (mm)
1INP65/62/84

Precautions

1. Charge the product fully before the first use.
2. Avoid using in-car chargers to charge the product, as their voltage and current may vary.
3. Do not disassemble the product, or use the product for any purpose other than that for which it was designed.
4. Do not charge the product in an enclosed space such as a car, in places that can become hot easily, or near a heat source.
5. Store and use at temperatures between 0 and 40°C.
6. Do not charge on heat-insulating surfaces such as carpets, blankets, sofas, beds, etc.
7. Do not expose the product to shocks, moisture, fire, sensitive skin, etc.
8. Do not allow the product to come into contact with water.
9. Only charge the product using a charger of appropriate voltage.
10. Keep the product out of reach of children.
11. Do not use the product in an environment where it may be damaged by pets.
12. If the product bloats due to battery malfunction, discontinue use of the product immediately.
13. When storing the product for an extended time period, charge the battery to 50% capacity every month.
14. This product is not waterproof, and no compensation shall be given in case of water damage.
15. Ensure that no conductive foreign materials enter the charger port.
16. Keep the product away from magnetic items such as credit cards, phone cards, bank books, traffic cards, etc, as the product may cause them damage.
17. Do not place in close proximity to computer monitors, televisions, or other similar electronic products
18. When charging wirelessly, the product’s temperature may increase slightly, so the smartphone may become hot; especially when using apps or games that use a significant amount of power.
19. Do not dispose of drained batteries irresponsibly.
20. When disposing of a used battery, do not place it in an incinerator or fire. Excessive heat may cause an explosion or fire.
21. When disposing of a secondary cell or battery, separate cells with different electrochemical systems and dispose of them separately
22. To prevent battery overheat, dispose of used batteries in a discharged state.
23. We recommend that the smartphone battery is charged wirelessly when attached to a STATIC smartphone case.
24. The manufacturer accepts no responsibility for damage to the product due to user negligence.
25. The warranty period for the product is 1 year from date of purchase.
26. Requires 7.5W or above Wall Charger.

FCC Part 15.19
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.

FCC Part 15.21
Any changes or modifications (including the antennas) to this device that are not expressly approved by the manufacturer may void the user’s authority to operate the equipment.
Note : This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a
residential installation This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications, However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help

RSS-Gen 8.4
This device contains licence-exempt transmitter(s)/receiver(s) that comply with Innovation, Science and Economic Development Canada’s licence-exempt RSS(s).
Operation is subject to the following two conditions:
(1) This device may not cause interference.
(2) This device must accept any interference, including interference that may cause undesired operation of the device.

FCC and ISED RF Radiation Exposure Statement:
This equipment complies with FCC and ISED RF Radiation exposure limits set forth for an uncontrolled environment. This device and its antenna must not be co-located or operating in conjunction with any other antenna or transmitter. This equipment should be installed and operated with a minimum distance of 20 cm between the radiator and your body

FCC/ ISED ID
– FCC ID: 2AY4GSTC-IP11
– ISED ID: 27062-STCIP11

Venda Stores Inc
6303 Blue Lagoon Drive Suite 400 Miami Florida 33126
Phone : 1-855-228-7127

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>