Verkada ACC-MNT-CORNER-1 Corner Mount Installation Guide
- June 12, 2024
- Verkada
Table of Contents
Install Guide
ACC-MNT-CORNER-1
Corner Mount
Introduction
What’s in the box
What you’ll need
- A compatible Verkade product
- 1/2 inch (12.7mm) drill bit, or larger, for routing cable through wall
- 5/16 inch (7.9mm) drill bit for sleeve anchors
- 13/32 inch (10mm) wrench for nuts
Compatible products
For a list of compatible products, please visit:
https://docs.verkada.com/docs/accessories-overview.pdf
Hole Patterns
- CD/CF series, Verkada mounts
- CB series
- CM series
- ACC-CAM-SHIELD-1
- ACC-MNT-XLARM-1
Installation
Mounting
Wall Mounting
Drill 5/16” pilot holes to a minimum depth of 1-¼”.
Clear the hole of debris and insert the sleeve anchors from Hardware Bag A
into the pilot holes using the side most slots. Fully secure the corner mount
by attaching nuts and tightening them.
Camera & Accessory Mounting
For detailed mounting instructions related to Verkada products, please see
their install guide. 
Appendix
Support
Thank you for purchasing this Verkada product. If for any reason you’re
experiencing issues or need assistance, please contact our 24/7 Technical
Support Team immediately.
Sincerely,
The Verkada Team
verkada.com/support
Verkada Inc. 405 E 4th Ave, San Mateo, CA 94401
sales@verkada.com
All specifications are subject to change without notice
© Copyright 2023 Verkada Inc. All rights reserved.
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>