ARRIS VIP7802 UHD IP Set Top with WiFi 6 Instructions
- June 6, 2024
- Arris
Table of Contents
ARRIS VIP7802 UHD IP Set Top with WiFi 6
The terms HDMI, HDMI High-Definition Multimedia Interface, and the HDMI Logo are trademarks or registered trademarks of HDMI Licensing Administrator, Inc. Manufactured under license from Dolby Laboratories. Dolby, Dolby Audio, Pro Logic and the double-D symbol are trademarks of Dolby Laboratories. The Bluetooth® word mark and logos are registered trademarks owned by Bluetooth SIG, Inc. and any use of such marks by CommScope is under license.
OVERVIEW
Front/Side panels
Rear panel
Important Safety Instructions
Never place the streamer on top of or close to any heat sources such as other
electronic devices. Doing so will reduce life time and may cause irreparable
damage or malfunction. Do not use the streamer near water. Note that the
ambient temper-ature must be below 104° F/40° C. Be sure to maintain necessary
space around the streamer to allow for proper ventilation. Never use the
streamer outside. The streamer is designed to stand on a horizontal surface.
Do not use any power supply other than the one supplied with the product.
Doing so may cause fire or seriously damage the streamer.
Ambient operating temperature| 32-104° F/0-40° C at 5-95% non condensing
humidity.
---|---
Voltage| 5Vdc, 2.0A
Power supply unit| This Class III product, VIP7802, shall be powered by the
Power Supply that is provided together with the product.
Typical power consumption| 10 W
Open Source Software Information
For instructions on how to obtain a copy of any source code being made
publicly available by ARRIS related to software used in this ARRIS product you
may send your request in writing to:
ARRIS, Software Pedigree Operations, 2450 Walsh Avenue, Santa Clara, CA 95051,
USA The ARRIS website opensource.arrisi.com
also contains information regarding use of open source. ARRIS has created the
opensource.arris.com site to serve as a portal
for interaction with the software community-at-large.
Innovation, Science and Economic Development Canada statement:
This device complies with Innovation, Science and Economic Development
Canada’s license-exempt RSSs. Operation is subject to the following two
conditions:
- This device may not cause interference; and
- This device must accept any interference, including interference that may cause undesired operation of the device. Caution:
- the device for operation in the band 5150–5250 MHz is only for indoor use to reduce the potential for harmful interference to co-channel mobile satellite systems;
- for devices with detachable antenna(s), the maximum antenna gain permitted for devices in the bands 5250-5350 MHz and 5470-5725 MHz shall be such that the equipment still complies with the e.i.r.p. limit;
- for devices with detachable antenna(s), the maximum antenna gain permitted for devices in the band 5725-5850 MHz shall be such that the equipment still complies with the e.i.r.p. limits specified for point-to-point and non-point-to-point operation as appropriate.
Radiation Exposure Statement:
This equipment complies with Canada radiation exposure limits set forth for an
uncontrolled environment. This equipment should be installed and operated with
minimum distance 20cm between the radiator and your body.
CANADIAN COMPLIANCE
This Class B digital apparatus meets all requirements of the Canadian
Interference Causing Equipment Regulations and CAN ICES-003 (B)/ NMB-003(B).
Cet appareil numérique de la classe B respects toutes les exigences du
Règlement sur le matériel brouilleur du Canada et CAN ICES-003 (B)/NMB-003(B).
Federal Communication Commission Interference Statement
This device complies with Part 15 of the FCC Rules. Operation is subject to
the following two conditions: (1) This device may not cause harmful
interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation. This equipment has
been tested and found to comply with the limits for a Class B digital device,
pursuant to Part 15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a residential
installation.
This equipment generates, uses and can radiate radio frequency energy and, if
not installed and used in accordance with the instructions, may cause harmful
interference to radio communications. However, there is no guarantee that
interference will not occur in a particular installation. If this equipment
does cause harmful interference to radio or television reception, which can be
determined by turning the equipment off and on, the user is encouraged to try
to correct the interference by one of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio
TV technician for help.
FCC Caution: Any changes or modifications not expressly approved by the
party responsible for compliance could void the user’s authority to operate
this equipment. This transmitter must not be co-locatedor operating in
conjunction with any other antenna or transmitter.
Radiation Exposure Statement:
This equipment complies with FCC radiation exposure limits set forth for an
uncontrolled environment. This equipment should be installed and operated with
minimum distance 20cm between the radiator and your body.
Caring for the environment by recycling
When you see this symbol on an ARRIS product, do not dispose of the product
with residential or commercial waste. Some countries or regions, such as the
European Union, have set up systems to collect and recycle electrical and
electronic waste items. Contact your local authorities for information about
practices established for your region. Please recycle product packaging and
this document.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>