Tribit BTS25S Portable Wireless Speaker User Manual
- June 6, 2024
- Tribit
Table of Contents
Tribit BTS25S Portable Wireless Speaker
Safety Precautions
- Avoid dropping the speaker on the floor.
- Do not try to disassemble or repair the speaker unless you are a technician.
- Do not submerge the speaker in water.
- Never expose the speaker to extremely high or low temperatures.
- Stop use immediately if a thunderstorm happens.
- Do not clean its surface with any corrosive cleanser or other chemical solutions.
Specifications
-
Bluetooth version: vs.a
-
Bluetooth profile: A2DP, AVRCP, HFP, HSP
-
Driver: 2 x CD45mm Passive radiator
-
Output power: 2 x 12W
-
Signal-to-noise ratio• 80dB
-
Frequency response: 80-20KHz
-
attery: 2×3.7V / 2200mAh
Music playtime: Up to 20 hours I vary by volume level and music files) -
Charging time: 4 hours@5V/1.5A
-
Dimensions: 65x198x68 mm/ 2.56×7.79×2.68 in
-
Weight: 595g / 20.98oz
What’s in the Box
Overview Buttons & Indicators
- Power Button
- Indicator
- Bluetooth Button
- MFB Taste
- Volume-
- Volume+
- EQ Mode Button
- Indicator
- AUX-IN Port
- Charging Port
Connections
Bluetooth Pairing
Stereo Mode
- Make sure both speakers are on.
- Press * on one of the speakers to enter the pairing state.
- Press * on the other speaker for Ss, then release the button to enter Stereo pairing when you hear the “Stereo mode”. When you hear “Left chanel “on the left speaker and ” Right chanel ” on the right speaker, the ” Stereo mode” is on.
| |
---|---|---
Function| Button| Operation
Power ON/OFF
| ****
Power Button
| Press t he button to turn on / off the speaker
Pair a Bluetooth
Device
| ****
Bluetooth Button
| Press the button to manually enter pairing mode
Volume Up
| ****
Volume +
| Press the button to increase the volume level
Volume Down
| ****
Volume-
| Press the button to decrease the volume level
Ploy/pause
| ****
MFB
| Press once the button
Next track
| ****
MFB
| Doub le press the button
Previous track
| ****
MFB
| Press the button for 3 times
| |
Answer/ end the incoming coll| MFB| Press once the button
---|---|---
Reject on incoming coll|
MFB
| Press and hold the button for 2s
Voice dial function
|
MFB
| Press and hold the button for 2s to activate ( your device
must support this function)
EQMode
|
XBASE
| Press the button to switch Music normal mode , Boss and Audiobook mode
Indicators
Power indicator
| Blue indicator flashes quickly| Bluetooth pairing mode
---|---|---
Blue indicator keeps sturdily on|
Connected
The red light is always on
| Charging/ battery <15% battery<2% prompts automatic shutdown
Greenlight is always o
|
Battery full
Power display
|
Mobile phone display
EQ Mode indicator
|
White indicator lights up
|
Bass Mode
Green indicator lights up
|
Audiobook Mode
Lights off
|
Normal Music Mode
Reset
If this speaker has any problem, you can try to press and hold Volume + and Volume – buttons simultaneously for 5s to reset this speaker and remove the old pairing in your Bluetooth device, and then pair again.
Customer Service
- 18-month limited warranty
- For FAQS and information, please visit: Email: support@tribit.co
www.tribit.com
IC Caution
This device contains a Science-exempt transmitter(s)/ receiver(s) that comply with Innovation, Science and Economic DevelopmentCanada’s licence-exempt RSS(s). Operation is subject to the following two conditions:
- This device may not cause interference.
- This device must accept any interference, including interference that may cause undesired operation of the device.
FCC Statement
Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment. Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment. This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 75 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio / TV technician for help.
This device complies with part 15 of the FCC rules. Operation is subject to the following two conditions:
- This device may not cause harmful interference.
- This device must accept any interference received, including interference that may cause undesired operation.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>