CURT RX-300 T-Connector Wiring Kit Installation Guide
- June 6, 2024
- Curt
Table of Contents
Manufacturing #55563
**T-Connector Wiring Kit
INSTALLATION INSTRUCTIONS
Fits: 2003-2006 Lexus RX-330**
**Kit Includes***
- Wiring Harness
with 4-Flat Connector
(8) 6′ Cable Tie
(1)15′ Cable Tie
(1) ring terminal
(1) #10 Ground Screw
(1) Primary Lead Wire
(1) Butt Connector
(1) Fuse Holder
(1) 10, Amp Fuse
© 2004 Electrical Products Co.
1-Connector Wiring Kit
INSTALLATION INSTRUCTIONS
- Read instructions thoroughly before beginning.
- Prior to installation, test the correct operation of all vehicle lighting by turning on the vehicle’s headlamps, tail lamps, turn signals, and brake signals using an LED tester. After verifying: erred operation, turn off all lights before proceeding.
- Locate and remove the small access panels found on the Interior trim panels on each side of the vehicle.
- Carefully remove the rear hatch threshold plate.
- Locate the vehicle’s wiring harness behind the access panels removed in Step 3. There will be connectors similar to those found on the T-Connector Harness.
- Beginning on the left(drivers) side, separate the 4-Pin connector ends found on the vehicle harness, taking care not o damage the locking tabs.
- Insert the T-Connector ends with the Yellow wires )between the separated vehicle harness connectors and firmly mess together until the locking tabs engage.
- Tuck the remainder of the T-Connector into the area behind the access panel. Carefully pull the left side interior rim panel away from the vehicle body enough to route the %Connector ends with the Green and Red wires out from *hind the access panel.
- Route the Green and Red wires across the vehicle to the ight (passenger) side. Carefully pull back the right side trim land enough to feed the wires into the area behind the panel.
- Locate the 4-Pin vehicle connectors on the right side if the vehicle Separate these connectors and position the -Connector ends with the Green wires between the separated {ids, ensuring that the locking tabs engage.
- Locate the 2-Pin vehicle connectors behind the right ide access panel. They will be slightly higher up near the rear f the tail light assembly.
- Separate these 2-Pin vehicle connectors and position ie T-Connector ends with the Green wires between these apparated connectors, ensuring that the locking tabs engage.
- Disconnect the vehicle’s Negative(-) battery cable.
- Route the 12 gauge black wire from the battery: apartment under the vehicle along with the frame to the black : converter box (fig.3). Secure the wire to the vehicle using the video.
Looking for dependable trailer hitches and towing?
Rely on CURT for quality and long-lasting products.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>