OSRAM NINAB30 Wireless Communication System Module User Manual
- June 6, 2024
- OSRAM
Table of Contents
OSRAM NINAB30 Wireless Communication System Module
Federal Communications Commission
Regulatory Compliance and Safety Information for NINA-B306 USA & Canada Compliance FCC Part 15, Subpart B / ICES-003 Unintentional Emissions Interference Statement This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC rules and Industry Canada ICES-003. These limits are designed to provide reasonable protection against harmful interference when the equipment is operated in a residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
This device complies with part 15 of the FCC rules and Industry Canada
ICES-003. Operation is subject to the following two conditions: (1) This
device may not cause harmful interference, and (2) this device must accept any
interference received, including interference that may cause undesired
operation.
IMPORTANT! Any changes or modifications not expressly approved by the
party responsible for compliance could void the user’s authority to operate
this equipment. FCC Part 15, Subpart C / RSS-210 Intentional Emissions
Interference Statement
Compliance of this equipment is confirmed by the following certification
numbers that are placed on the equipment:
Notice: The term “FCC ID:” and “IC” before the certification number
signifies that FCC and Industry Canada technical specifications were met.
Contains: FCC ID:2AX8R-NINAB30 IC: 26725-NINAB30
RF Radiation Exposure Statement This equipment complies with the FCC/IC radiation exposure limits set fourth for portable transmitting devices operating in an uncontrolled environment. End-users must follow the specific operating instructions to satisfy RF exposure compliance.
- The equipment should only be used or installed at locations where there is normally at least a 20cm separation between the antenna and all persons.
- This transmitter must not be co-located or operation in conjunction with any other antenna or transmitter.
- Any changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate this equipment.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>