KAYOBA 000077 Lockable Cat Flap Instruction Manual
- June 6, 2024
- KAYOBA
Table of Contents
KAYOBA 000077 Lockable Cat Flap
OPERATING INSTRUCTIONS
Important! Read the user instructions carefully before use. Save them for future reference. (Translation of the original instructions).
Care for the environment!
Recycle discarded product in accordance with local regulations. Jula reserves
the right to make changes. For latest version of operating instructions, see
www.jula.com
Read the operating instructions carefully before use.
Save these instructions for future reference.
DESCRIPTION
- Jigsaw
- Drill
- Sandpaper
- Tape measure
- Pencil
- Glue
- Ruler
- Screwdriver
Suitable for doors with different thickness (up to 60 mm).
INSTALLATION
2:1 Measurement and marking
First, measure the hight of the cat. This is usually 100-150 mm.
Please note: This will be the bottom of the hole and the flap frame will
be lower. If neccessary, this line might have to be raised to account for
this. For more than one cat, fit the cap flap based on the measurement of the
smallest cat to prevent injuty to any of the cats. Important! Fitting the cat
flap at an incorrect height could cause injury to the cat.
2:2 In doors
The cat flap requires a rectangle cut out of wood/plastic of 155 mm x 160 mm, making sure the bottom of the rectangle is level with the line you drew.
2:3 In glas
The cat flap requires a circular cut-out with diameter of 220 mm. Please make
sure that the bottom of the circle is lower than the line you drew.
Please note! It is not possible to cut holes in toughened glass or double
glazed. For best result consult a glazier.
2:4 Fitting the cap
- Temporarily place the cat flap in the hole and position the outside cover on the outside of the house.
- From the outside mark screw holes in the outside cover (A).
- Remove the cat flap and drill holes with a 3,5 mm drill bit (B).
- Replace the cat flap in the hole and from the outside screw into place.
- The screws should go through the door and into the screw holes on the back of the inside part of the cat flap.
Please note: The depths of some doors vary. You may need to purchase different screws to fit the door better without damaging the cat flap.
USE
The magnet will keep the flap shut against wind even in totally open situation. At the same time, the brush will be able to seal the door completely. Made of durable and coldresistant material. The brush can be replaced and cleaned.
3:1 Control positions
- Flap completely locked.
- Free passage in both directions
- A cat can only go into the house
- A cat can only go out of the house.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>