verizon LVR2 Home Router User Guide
- June 6, 2024
- Verizon
Table of Contents
Verizon Router
User Guide
Chapter 1 Introduction
The Verizon Router provides superior Wi-Fi performance with Tri-band support
and low latency to support gaming and VR use cases.
The innovative design of the Verizon Router allows customers to connect their
favorite devices to Verizon’s 5G Network.
Unboxing Information
Inside the product package for the Verizon Router, you should find the following items:
Product Overview
Front
Bottom
| Part | Description |
|---|---|
| LED | The LED lights up in different ways to indicate the connectivity status |
of the VerizonRouter.
Rear panel
| Part | Description |
|---|---|
| WPS button | Press this button once to connect the Verizon Router to Wi-Fi |
Extender or devices via WPS. After the pairing is successful, the LED light
will stop blinking blue.
RJ45 port| Connect the Verizon Router to PC or switch via an Ethernet cable.
Coax| Connect the Verizon Router to your TV via a coaxial cable.
Reset pin hole| Factory reset the device by pressing the pin hole for 5
seconds.
DC jack| Connect the power adaptor to the DC jack to provide power to the
Verizon Router from an electrical outlet.
LED and Audio Behavior
| Front LED | Status |
|---|---|
| Device booting up | Soft blink white |
| Solid white | Setup complete |
| 50% brightness solid white | Signs of life |
| Hard blink red | Hardware/system failure; no Internet connectivity |
| Soft blink white | Firmware update/Factory reset in progress |
| Fast blink red | Firmware update error |
| Soft blink yellow | Wi-Fi is disabled |
| Hard blink blue | WPS pairing in progress |
| Fast blink blue | WPS pairing is successful |
| Fast blink red | WPS pairing has failed |
Chapter 2 Setup and Activation
Installation, Activation, and Setup
This section describes how to set up and configure your Verizon Router.
Setting up the Verizon Router
- Unbox the Verizon Router, AC adaptor, and Ethernet cable.
- Attach the power cord to the AC wall adapter power supply.
- Plug the power cord into the power port on the back of the Verizon Router.
- Plug the power adapter into an AC wall outlet.
WPS Connection
WPS can be used to pair your Verizon Router to other devices by following these steps:
- Short press the WPS button on your Verizon Router.
- Short press the WPS button on the device with which you want to pair your Verizon Router, making sure the device is within range of the Verizon Router.
- The Verizon Router will play a sound to indicate pairing is successful.
Chapter 3 Product Specifications
Wi-Fi| • 2.4GHz 802.11ax 4×4 MIMO
• 5GHz 802.11ax 4×4 MIMO
• 6GHz 802.11ax 4×4 MIMO
• Backwards compatible with 11ac/11n/11b
---|---
Memory| • Router:
1 GB DDR4 RAM × 2
Storage| • Router: 4 GB eMMC
Dimensions| • 120 x 120 x 250.25 mm
Weight| • 1.344 KG
Connector| • 10GbE Ethernet × 1 (WAN)
• 10GbE Ethernet × 1 (LAN)
• 2.5GbE Ethernet × 2 (LAN)
• MoCA2.5 × 1 (LAN)
• USB Type C 3.0 × 1
Button| • Sync button x 1
• Reset button x 1
Operating Temperature| • 0 °C–40 °C
Federal Communication Commission Interference Statement
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/ TV technician for help.
FCC Caution: Any changes or modifications not expressly approved by the
grantee of this device could void the user’s authority to operate the
equipment.
This device and its antenna(s) must not be co-located or operating in
conjunction with any other antenna or transmitter.
FCC regulations restrict the operation of this device to indoor use only.
The operation of this device is prohibited on oil platforms, cars, trains,
boats, and aircraft, except that operation of this device is permitted in
large aircraft while flying above 10,000 feet.
Operation of transmitters in the 5.925-7.125 GHz band is prohibited for
control of or communications with unmanned aircraft systems.
FCC Radiation Exposure Statement
This equipment complies with FCC radiation exposure limits set forth for an
uncontrolled environment.
This equipment should be installed and operated with minimum distance 20cm
between the radiator and your body.
This device complies with Part 15 of the FCC Rules. Operation is subject to
the following two conditions: (1) this device may not cause harmful
interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.
Important Notice
The user is responsible for determining whether surfaces and installation
environments are appropriate. Please remember that many factors influence
installation safety. Please follow the user manual. Materials, flatness,
cleanliness of surfaces, humidity, wind speed, time, and many other factors
can affect the adhesiveness and fixedness of this product. Verizon does not
guarantee the product can be fixed and will not fall. Given the variety of
factors that can affect the adhesion and fixedness, it is essential that the
user evaluates the conditions of surfaces and the environment to determine
whether they are suitable for installation.
DISCLAIMER
TO THE MAXIMUM EXTENT PERMITTED BY APPLICABLE LAW, VERIZON MAKES NO OTHER
WARRANTIES, EITHER EXPRESS, IMPLIED, OR STATUTORY. VERIZON DISCLAIMS ANY
LIABILITY CAUSED BY ANY USER’S NON-COMPLIANCE WITH THE USER MANUAL.
Safety Warnings
Adapter
Do not use any other power adaptor except for the one that accompanies this
unit or a power adaptor identified in the list below.
Use of another adapter could result in damage to the unit.
The following power adaptor is qualified for use with this Verizon Router:
This unit must be powered by LUCENT TRANS, model 1A98-1250; 12V, 5A, 60W
Caution
Ensure to connect the power cord of the power adapter to a socket outlet with
a grounding connection.
The cable distribution system should be grounded (earthed) in accordance with
ANS/NFPA 70, the National Electrical Code (NEC), Article 820, in particular
Section 820.93, Grounding of Outer Conductive Shield of a Coaxial Cable.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>