uleFone Note 12P Smartphone User Guide
- June 6, 2024
- uleFone
Table of Contents
Note 12P
Quick Guide
Follow us on Facebook
LANGUAGE: EN/DE/FR/ES/IT/RU/UA/JP
- Headset Jack
- Front Camera
- Light Sensor
- Receiver
- LED Notification Light
- Screen
- Speaker
- USB Port
- Microphone
- Card Slot
- Rear Camera
- Flash
- Volume +
- Volume –
- Power Key/ Fingerprint
Insert the cards
Slot 1: TF Card
Slot 2: Nano SIM2
Slot 3: Nano SIM1
Note:
- Do not use a hand-cut card or wrong type card in case of card slot getting damaged.
- Insert the card when the phone is power off.
- TF card is up to 128 GB.
Network Bands:
GSM: 1900/1800/850/900 (B2/3/5/8)
WCDMA: 2100/1900/1700/850/900 (B1/2/4/5/8)
LTE-FDD: 2100/1900/1800/1700/850/2600/900/
700/700/800/800(B1/2/3/4/5/7/8/12/17/19/20)
Face Unlock:
Setting > FaceUnLock
Network Connection
WiFi: Setting > Network & Internet > WiFi
Hotspot: Setting > Network & Internet > Hotspot&tethering
Declaration of Conformity (DoC)
We, Shenzhen Gotron Electronic CO.,LTD.
Declare that the DoC is issued under our sole responsibility:
This device is in compliance with Specific Absorption Rate (SAR) for general population/uncontrolled exposure limits (2.0 W/kg) specified in COUNCIL RECOMMENDATION 1999/519/EC, and had been tested in accordance with the measurement methods and procedures specified in EN 62209-1: 2016 & EN 62209-2:2010. For details, please refer to the product CE report.
The maximum power of product testing is within the standard range, which meets the requirements of EU standards. For details, please refer to the product CE report.
Use careful with the earphone maybe possible excessive sound pressure from earphones and headphones can cause hearing loss.
The product shall only be connected to a USB interface of version USB2.0 Adapter shall be installed near the equipment and shall be easily accessible. The plug considered as disconnect device of adapter.
CAUTION: RISK OF EXPLOSION IF BATTERY IS REPLACED BY AN INCORRECT TYPE. DISPOSE OF USED BATTERIES ACCORDING TO THE INSTRUCTIONS
Care for the environment! Must not be discarded with household waste!
This product can be used across EU member states, but with restriction.
The object of the declaration described above is in conformity with the
essential requirements of the relevant Union harmonization legislation:
Radio Equipment Directive RED (2014/53/EU).
The harmonized standards and technical specifications are as follows:
HEALTH & SAFETY (Art. 3(1)(a)):
EN 50360:2017; EN 50566:2017; EN 62209-1:2016; EN 62209-2:2010; EN 62479:2010
EN 62368-1:2014+A11:2017
EMC (Art. 3(1)(b)):
ETSI EN 301 489-1 V2.2.3 (2019-11)
ETSI EN 301 489-3 V2.1.1 (2019-03)
(Draft) ETSI EN 301 489-17 V3.2.2 (2019-12)
ETSI EN 301 489-19 V2.1.1 (2019-04)
(Draft) ETSI EN 301 489-52 V1.1.0 (2016-11)
EN 55032:2015
EN 55035:2017
EN 61000-3-2:2014
EN 61000-3-3:2013
Radio Spectrum (Article 3.2):
ETSI EN 301 511 V12.5.1(2017-03)
ETSI EN 301 908-1 V11.1.1(2016-07)
ETSI EN 301 908-2 V11.1.2(2017-08)
ETSI EN 301 908-13 V11 1 2(2017-07)
ETSI EN 300 328 V2.1.1(2016-11)
ETSI EN 303 413 V1 1.1(2017-06)
ETSI EN 303 345-3 V1.1.0(2019-11)
The product have been applied the above standards according to the different functions supported. For details, please refer to the product CE report.
Notified Body Involved:
Notified Body: MET Laboratories, Inc.
Notified Body Number: 0980
Activity Performed: EU-Type Examination (Module B)
ulefone®
All Rights Reserved
The information contained herein is subject to change without notice The only warranties for Ulefone products and services are set forth in the express warranty statements accompanying such products and services.
Nothing herein should be construed as constituting an additional warranty. Ulefone shall not be liable for technical or editorial errors or omissions contained herein.
Shenzhen Gotron Electronic CO., LTD.
Address: Floor 7, Building A, Block 1, Anhongji
Tianyao Plaza, Longhua District, Shenzhen City,
Guangdong Province China
Service Center
Email : service@ulefone.com
FCC Caution:
Any changes or modifications not expressly approved by the party responsible
for compliance could void the user’s authority to operate this equipment.
This device complies with Part 15 of the FCC Rules.. Operation is subject to
the following two conditions.
(1) This device may not cause harmful interference, and
(2) this device must accept any interference received, including interference
that may cause undesired operation.
This Product meets the government’s requirements for exposure to radio waves.
The guidelines are based on standards that were developed by independent
scientific organizations through periodic and thorough evaluation of
scientific studies. The standards include a substantial safety margin designed
to assure the safety of all persons regardless of age or health.
FCC RF Exposure Information and Statement the SAR limit of USA (FCC) is1.6 W/kg averaged over one gram of this Device GQ3278 (FCC ID:2AT9T-3278) has been tested against this SAR limit. SAR information on this can be viewed on-line at http://www.fcc.gov/oet/ea/fccid/. Please use the device FCC ID number for search. This device was tested for typical operations 10mm from the body. To maintain compliance with FCC RF exposure requirements, 10mm separation distance should. maintained to the user’s bodies
NOTE:
This equipment has been tested and found to comply with the limits for a Class
B digital device, pursuant to Part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates, uses and can radiate
radiofrequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications.
However,
there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and
on, the user is encouraged to try to correct the interference by one or more
of the following measures:
— Reorient or relocate the receiving antenna.
— Increase the separation between the equipment and receiver.
— Connect the equipment into an outlet on a circuit different from that to
which the receiver is connected.
— Consult the dealer or an experienced radio/TV technician for help.
References
- Alza.cz – rychlý a pohodlný nákup odkudkoliv | Alza.cz
- Alza | Alza.co.uk
- Alza.cz – rychlý a pohodlný nákup odkudkoliv | Alza.cz
- Alza.cz
- alza.de
- alza.hu
- alza.sk